Lavina 25-X User Manual - page 5
Superabrasive
User Manual
Original Language
Lavina® 25‐X
3/2015
5
1. GENERAL INFORMATION
This owner’s manual is intended for the operator of the Lavina® X machine, the servicing technician as well as for anyone
involved with operating or servicing the machine. We recommend that you read the instructions very carefully and follow them
strictly.The manual includes information about assembling, using, handling, adjusting and maintaining your Lavina® X floor
grinding andpolishing machine.
MANUFACTURER
Superabrasive was founded in 1987, as a manufacturer of high quality diamond tools for the stone and concrete industry. Today,
Superabrasive is one of the world’s leading companies in the production of diamond tools and floor grinding machinery. At
Superabrasive, we strive to deliver the very best solutions to our customers, and enable them to work more efficiently.
GENERAL DESCRIPTION
The Lavina® X machine is intended for grinding, polishing and buffing concrete, marble, granite, limestone, and terrazzo surfaces
with diamond tools.
The Lavina® X machine is a three‐disc machine, which can be used dry as well as wet.
For best results, use only tools manufactured or recommended by Superabrasive and its distributors. Additionally, the machine
could be used for grinding wood floor surfaces.
The Lavina® X machine is manufactured and fitted for the above‐mentioned applications only! Every other
use may possess risks to the persons involved.
MACHINE CHARACTERISTICS
The Lavina® X machine is made of two main component sections:
MAIN DESIGN
The two main component sections, are the carriage and main head.
The handle (Fig.1.2) on the frame is adjustable in height and allows the operator to work
in
a correct and safe working posture.
The halogen spotlight (Fig.1.2) enables the operator to work in darker areas.
Existing lighting system does not replace adequate overhead
lighting.
The controls are positioned on top of the electrical box (fig.1.3)
The electrical box (fig.1.3) contains the electric switching devices and the inverter.
The main feeding cable is connected with a plug and socket on top. The motor feeding
cable is plugged into the socket located on the bottom of the box.
The tank is on the opposite side of the frame, so that the weight of the
water has no influence on the operation of the machine. The frame weight, on the other
hand, is fully absorbed by the driving wheels. An electric pump sprays the water through
a front sprayer or internal.
The motor is mounted on the base plate and is driving the three heads with a belt
system.
The planetary head is driven by a simplex roller chain
.
ENVIRONMENTAL CONDITIONS
The temperature range for operating the Lavina® X machine outdoors is between 41°F
and 86°F or 5°C and 30°C. Never use the Lavina® X machine during rain or snow when
working outdoors. When working indoors, always operate the machine in well‐ventilated
areas.
ELECTRICAL CONNECTION
The voltage (Volt) and power (Ampere) are displayed on a label on the electrical control
box to avoid any incorrect connection. Refer to these before connecting the power. To avoid electrical shocks, make sure the
ground power supply is functioning properly.
Figure 1.3
Figure 1.2
Figure 1.1