LCG LCG-072 User Manual - page 10
10
•
1
•
3
•
2
1.
1
2.
3
3.
2
INPUT
OUTPUT
COMMON
DMX +
DMX -
Termination reduces signal errors and to avoid signal transmission problems and
interference. It is always advisable to connect a DMX terminal.
(resistance 120ohm
1/4W ) between pin2 (DNX-) and pin3 (DMX+)
of the last fixture.
1. Connect the fixture together in a “daisy chain” by XLR plug cable from the
output of the fixture to the input of the next fixture. The cable cannot be
branched or split to a 2Y” cable. Inadequate or damaged cables, soldered
joints or corroded connectors can easily distort the signal and shut down the
system.
2. The DMX output and input connectors are pass-through to maintain the DMX
circuit when no power is connected to the fixture.
3. At last fixture, the DMX cable has to be terminated with a terminator to
reduce signal errors. Solder a 120-ohm 1/4W resistor between pin 2(DMX-)
and pin 3(DMX+) into a 3-pin XLR-plug and plug it in the DMX-output of the
last fixture.
4. Each lighting fixture needs to have an address set to receive the data sent by
the controller. The address number is between 0-511 (usually 0 & 1 are
equal to 1).
5.
5.
5.
5. 3 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+).
Notice:
Notice:
Notice:
Notice:
A. If no any touch the button within 20 seconds, the LED display will be close, if touch
any button at this time, the LED display will be recover the original status. All the
button will be recover the function,
B. This fixture have the excess temperature self defective function. When the
brightness is obvious reduce, please check if the fan work in normal, after clear the
trouble clear, please power supply, the light will be release defend, and work in
normal.
C. Turn on the fixture, it will show the Version No. like V2.0.
It will keeps two
seconds, then under the working mode which the user set up.
6
666. TROUBLESHOOTING
TROUBLESHOOTING
TROUBLESHOOTING
TROUBLESHOOTING