LCG LCG-072 User Manual - page 8
8
button ,you can select 7 static colors (1.-r ;2.-rg;3.-g;4.-gb;5.-b;
6.-rb ; 7.rgb; 8OFF).Press SETUP again, you can press UP or DOWN
adjust the brightness of the static colors .Press SETUP button can
setup the flash “FSxx” of the color .Also press UP or DOWN can adjust
the speed of flash of speed.
g.
g.
g.
g.IR
IR
IR
IR Remote
Remote
Remote
Remote
1. Press the “mode”, when LED display:-ir- is on IR remote.
IR remote instruction as below:
A
A
A
A) select
select
select
select the
the
the
the built-in
built-in
built-in
built-in programs
programs
programs
programs by
by
by
by IR
IR
IR
IR remote
remote
remote
remote:
1) Press down the “AUTO”, enter the built-in program select mode.
Press down the “+”/“-”, select the built-in programs Pr.01~Pr.35.
(Note: the button “AUTO” function amount to press the button Pr.xx).
2) Press down the “SPEED”, enter to the state of built-in program running speed,
press down the “+”/“-”, adjust the built-in program running speed.
3) Press down the “STROBE”, enter to strobe state, press down the “+”/“-”, adjust
the speed rate of built-in programs, and then press the “STROBE”, the
stroboscopic stop.
4) Press down the “FADE”, the light color will from one change to another one,
press down the “FADE” again, the light color will from one hopping to another
one.
B
B
B
B) select
select
select
select the
the
the
the sound
sound
sound
sound active
active
active
active mode
mode
mode
mode by
by
by
by IR
IR
IR
IR remote
remote
remote
remote:
1) Press the “SOUND” or “SENSITIVITY”, enter sound active mode, press down
the “+”/“-”, adjust the sensitivity of sound active.
2)select the static color mode by IR remote:
Press the “MANUAL”, enter to select the static color,
Press the numeric buttons “0”~“9”,select the fixed monochrome:
0
1
2
3
4
5
6
7
8
9
Whit
e
Red
Orang
e
Yello
w
Gree
n
Cyan
Blue
Purpl
e
Pink
Ambe
r
3)press down the “MANUAL”, enter select the static color mode, press down the
“R ”(“G” or “B”) enter to dimming color
mode,
Press the “0”-“9”in turn ,the first input is higher,the effectively composed
number between 0-100, press the “%” again,
confirm this number is the
percentage of dimming monochrome.
For example, press the “MANUAL”+“R”+“5”+“0”+“%” in turn, set the red LED
brightness is 50% of all the bright.
When adjust one monochrome, press a effectively number, the correspond color
will fading up once, if the setting is ok, the light board will lighting the
monochrome which you setting. If the setting is wrong, the light board will
display the color before you set, can reset the color.
4)press down the “R” or “G” or “B”,display the user-defined color, press down