LD LDDSP45K User Manual - page 15
IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
DEUTSCH
ENGLISH
15
•••
SPEAKER DYNAMIC CONTROL
88
89
88
90
91
92
91
93
94
95
94
96
98
99
100
101
102
103
102
104
105
106
107
109
108
110
112
111
114
108
113
115
SPEAKER RMS DYNAMIC CONTROL
88
LIMIT – click the arrow icons to adjust the limiter in accordance with the RMS capacity of the speaker.
89
Virtual Fader – click and hold the virtual FADER button and drag it up or down to adjust the limiter in accordance with the RMS
capacity of the speaker.
90
Display/input field – direct input via keyboard and display of the limiting in watts RMS.
91
RATIO – for use as a compressor, click the arrow icons to adjust the control ratio.
92
Virtual Fader – click and hold the virtual fader button and drag it up or down to adjust the control ratio when using as a compressor.
93
Display/input field – direct input via keyboard and display of control ratio.
94
KNEE – click the arrow icons to adjust the characteristic curve at the level of the threshold value (in this case W RMS)
(low value = hard transition between unprocessed and processed signal, high value = soft transition between the
unprocessed and processed signal).
95
Virtual Fader – click and hold the virtual fader button and drag it up or down to adjust the characteristic curve at the level of the
threshold value (in this case W RMS).
96
Display/input field – direct input via keyboard and display of value.
97
RMS DETECTOR – BYPASS – RMS DYNAMIC CONTROL deactivated (click button).
COMPRESSOR – click to use as a compressor.
LIMITER – click to use as a limiter.
98
Auto TC – check the box for automatic adjustment of attack, hold time and release.
99
ATTACK – use arrow symbols for manual setting of response time and direct input via keyboard (remove check for Auto TC).
100
HOLD TIME – use the arrow symbols for manual setting of hold time and direct input via keyboard (remove check for Auto TC).
101
RELEASE – use the arrow symbols for manual setting of release time and direct input via keyboard (remove check for Auto TC).
SPEAKER PEAK DYNAMIC CONTROL
102
LIMIT – click the arrow icons to adjust the limiter in accordance with the peak capacity of the speaker.
103
Virtual Fader – click and hold the virtual fader button and drag it up or down to adjust the limiter in accordance with the peak capacity
of the speaker.
104
Display/input field – direct input via keyboard and display of the limiting in watts PEAK.
105
Auto TC – check the box for automatic adjustment of attack and release time.
106
ATTACK – direct input via keyboard and for setting the response time using the arrow symbols (remove check for Auto TC).
107
RELEASE – use the arrow symbols for manual setting of release time and direct input via keyboard (remove check for Auto TC).
108
KNEE – click the arrow icons to adjust the characteristic curve at the level of the threshold value (in this case W PEAK)
(low value = hard transition between unprocessed and processed signal, high value = soft transition between the
unprocessed and processed signal).
109
Virtual Fader – click and hold the virtual fader button and drag it up or down to adjust the characteristic curve at the level of the
threshold value (in this case W PEAK).