LD LDESUB15AG3 User Manual - page 5
IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
DEUTSCH
ENGLISH
5
CONNECTIONS, CONTROLS AND INDICATORS
1
INPUT LINE LEFT / RIGHT
Balanced line inputs (XLR / 6.3 mm jack combo) for left and right channels (LEFT + RIGHT). Signals that are applied at both inputs are
summed internally as Mono. The use of unbalanced cables (e.g. mono jack) is also possible, however, balanced cables are preferable due to
the greater noise immunity.
2
MAIN LEVEL
Rotary encoder for the total volume. Turning the controller to the left decreases the volume; turning it to the right increases it.
3
MODE
Switch to switch between DSP presets. The different presets are retrieved by repeatedly pressing the switch
(check the LED indicator).
80 Hz:
Preset with low-pass filter at 80 Hertz
100 Hz:
Preset with low-pass filter at 100 Hertz. Ideal setting in combination with Stinger G3 full-range speakers to maintain balanced
level settings. Preset for the forward-facing subwoofer in the subwoofer cardioid set-up (see CARDIOID ARRAY)
120 Hz:
Preset with low-pass filter at 120 Hertz
CARDIOID:
Preset for configuring three Stinger G3 subwoofers of same model as a cardioid array (entral, rear-facing subwoofer, see
CARDIOID ARRAY).
All Stinger
®
G3 enclosures are made of rigid, low-resonance birch ply. They are coated with non-abrasive, impact resistant
polyurea for superior strength and unrivaled durability. Integrating LD Systems’ Dual-Tilt pole mount, multiple suspension
points, stacking recesses and ergonomic handles the Stinger
®
G3 Series has been designed for touring musicians, rental
companies and installation applications. The large selection of Stinger
®
accessories includes smart wall and truss mounting
hardware plus a stackable dolly board to facilitate transport. Isn’t it time you saddled up?
3
2
4
1
1
5
5
6
7
8