LD LDESUB15AG3 User Manual - page 6
6
DEUTSCH
FRANCAIS
ESP
AÑOL
ENGLISH
IT
ALIANO
POLSKI
4
STATUS-LEDS
ON:
Lights up once the system is properly connected to the power mains and switched on.
SIGNAL:
Lights up as soon as an audio signal is present.
LIMIT:
Lights up if the loudspeaker system is operating in the clipping range. A short flash of the LED in this instance is
not critical. To protect the system, an excessive signal level is gently turned down by the built-in limiters.
If the limiter LED lights up permanently or for longer periods, reduce the volume level. Failure to do so may result in a distorted
sound and damage to the speaker system.
PROTECT:
Lights up if the system is overloaded/overheated. The amplifiers are muted automatically. Upon
reaching normal operating conditions, the device reverts to normal operating mode after a few minutes.
5
THRU LEFT RIGHT
Balanced line inputs with 3-pin male XLR sockets. The input signal (INPUT LINE) is routed without alteration to the line output THRU.
6
POWER IN
Blue power input socket for power supply to the device. A suitable power cable is included. For the device’s maximum power input without
allowing for the POWER OUT load rating, please see the label under “STINGER SUB 15 / 18 AG3” only.
7
POWER ON / OFF
On / Off switch for the power supply of the device.
8
POWER OUT
White power output socket. See label on device for maximum load rating.
WHAT DOES LD SYSTEMS DynX
®
DSP STAND FOR?
DSP stands for Digital Signal Processing, DynX® comprises the Limiter, EQ, Compressor and Crossover features. The digital signal process-
ing ensures maximum audio performance with maximum clarity and protects the PA system from overload.
WHAT EXACTLY DOES DynX
®
DSP DO?
The Limiter function protects the speakers and prevents distortions caused by overload. A limiter attenuates the signal when the level
exceeds a value which could have a negative effect. The system can be operated in this manner with a higher overall sound pressure as
extreme peaks are automatically lowered, so that the total volume does not need to be reduced.
The Multiband EQ works in the lower frequency range, a low-pass filter prevents the transmission of high-frequency signals. The amplitude
and runtime optimisation is perfectly adapted to the full-range speakers of the Stinger G3 Series.
SUBWOFFER 100 HZ + SATELLITE
20 Hz
100 Hz
1 kHz
20 kHz
SATELLITE
SUBWOOFER
TOTAL