LD SAT242 User Manual - Passive Speaker

ENGLISH

DEUTSCH

FRANCAIS

FRANCAIS

FRANCAIS

FRANCAIS

FRANCAIS

ES

pA

ño

L

po

LSKI

IT

ALIAN

o

6

PASSIVE SPEAKER

lD SAT42(W) / SAT242(W)

Up to 4 SAT42(W) (up to 2 SAT242(W) ) loudspeakers per power amp output can be connected in parallel on 4 

ohms. At the rear connection terminal, the loudspeaker signal is simply looped through to the next SAT42(W) 

(SAT242(W) ) speaker.

lD SAT62(W)

Up to 4 SAT62(W) loudspeakers per power amp output can be connected in parallel 4 ohms. At the rear connec-

tion terminal, the loudspeaker signal is simply looped through to the next SAT62(W) speaker.

lD SAT82(W)

2 pieces of SAT82(W) loudspeakers per power amp output can be connected in parallel 4 ohms. At the rear 

connection terminal, the loudspeaker signal is simply looped through to the next SAT82.

lD SUB88 in connection with the lD SAT 42/242/62(W)

Connect the loudspeaker cables coming from the power amplifier to the subwoofer connection terminals labelled 

Input A and B. Then connect the satellites SAT42/242(W) or SAT62(W) to the connection terminals labelled Output 

A and B. Up to 4 SAT42(W) / SAT62(W) or up to 2 SAT242(W) satellites can be connected in this combination on 

4 ohms. We recommend loudspeaker cables such as the Adam Hall KLS 215, with a cross-section of at least 2 x 

1.5 mm².

OPERATINg INfORMATION:

AcTIVE SPEAKER

lD SAT62A 

MoUnTIng / InSTAllATIon

It is recommended to switch the system to ON as the last one and to OFF as the first one to prevent start-up 

noise caused by a connected device like a mixer etc.. Additional connected LD SAT62A should be switched to ON 

in order from the first to the last one and should be switched to OFF in reversed order. If the AUTO mode is used 

the source should be turned to off only after 10 minutes without any signal to make sure, that the connected LD 

SAT62A are in Standby mode.

connEcTIng AnD oPERATIng

To connect the LD SAT62A the device should be turned to OFF. There is a connection using 6.3 mm jacks (ba-

lanced triple pole / unbalanced two pole) possible as well as a balanced connection using triple pole XLR plugs. 

After connecting all necessary cables and the MAIN LEVEL adjust is turned counterclockwise to left end stop the 

source device can be turned to on. Then the LD SAT62A can be turned to ON too (see above). Please turn the 

MAIN LEVEL adjust clockwise until designated level is reached. Please do so for additional LD SAT62A if used. 

The Connection and operating elements of LD SAT62A are shown on the 

back panel active speakers page.

SIgnAl looPIng 

The LD SAT62A system is designed to loop the signal to additional devices via triple pole XLR cable. It is not 

necessary to connect each device using an own connection to the source. Please make sure that XLR cables of a 

good quality are used and that the cables are installed in safe way.