LD SAT242 User Manual - Back Panel Active Speaker:
ENGLISH
DEUTSCH
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
ES
pA
ño
L
po
LSKI
IT
ALIAN
o
8
BAcK PAnEl AcTIVE SPEAkER:
lD SAT62A
1
MAIn lEVEl
Adjusts the speakers volume
2
PoWER MoDE
Switches to contineous on (ON) or to standby mode (AUTO). In position AUTO the amplifier is turned to ON
by receiving a signal. After several minutes without any signal the amplifier turns again to standby mode.
3
PoWER lED
Lights up RED if device is in STANDBY mode. Lights up GREEN if device is turned ON.
4
InPUT XlR / 6.3 mm jack
Balanced Line Input for XLR connectors and 6.3 mm jacks.
5
lInE DIREcT oUTPUT
Direct, balanced Line Ouput for XLR connectors. Should be used to loop the signal to another LD SAT62A.
6
PoWER SWITcH
ON / OFF switch.
7
PoWER connEcTIon SEAT
Power connection seat 240 V (IEC power connector) and fuse seat. Replacement of fuse only if mains power
is disconnected and only by fuse of same type and rating (T1A 250V AC). If fuse blows repeatedly please
contact authorized personel for servicing.
8
oVERloAD lED
Lights up when speaker is overloaded. Reduce volume immediately.