LDA MPS-8Z S02 User Manual - page 19
5.3.6 CONFIGURATION. OUTPUT VOLUME
To configure the output volume push the zone memory 7 button to increase the volume and
the zone memory 8 button to decrease it. Each tap of the button area lights up of the associated
indicator as confirmation. When the maximum volume is reached, the corresponding indicator to
zone memory 7 will light up. Similarly, when the minimum volume is reached the zone memory 8
indicator will stay on.
To confirm the new configuration press "TALK"; to cancel press "CANCEL"
5.4 EXPANSION KEYBOARDS CONNECTION
The microphone desk MPS 8Z can equip up to 7 expansion keyboards with 8 zone
memories each one. It has two expansion ports (one on each side) to connect the expansion
keyboards, thus keyboards can be installed next in the left or right side of the MPS 8Z. Expansion
keyboards can only be installed in one of the two directions.
To do the installation proceed as follows:
•
Disconnect the MPS 8Z from the bus and its peripheral power supply
•
Place the adapter (provided with the expansion keyboard) on the chosen side and match
the sides of both teams until the electric connection is complete.
•
Turn over both equipments and screw the union metallic accesory that blocks the bodies of
the equipments.
•
Configure the expansion keyboard ID as described in section 3.2.9
•
Reconnect the MPS 8Z to the system. By default the new keys will take the parts of the
system as described in section 3.2.9
6 UPDATE
If a firmware update of the equipment is required, make sure that the update image
provided matches your model. If the equipment has expansion keyboards connected it is not
required to disconnect them.
The update is made from the Configuration Software of the NEO system, In the device
view it will be possible to send a firmware update.
The update process is made automatically from the NEO equipment to the ACSI devices.
This may take a few minutes depending on the device and the system. During this time the device
will not be operational.
NOTE: The firmware update is only allowed for devices version 1.0.1 or later. The version
can be checked from the system configuration application.
12
www.lda-audiotech.com