Le Club HEZO300ZR User Manual - page 5
English
HEZO300ZR
-Moving head with 19 x 15W 4-in-1 RGBW LEDs, pixel and zoom
Page 5
1
LED indicators
Indicate the status of your device
LED
Indication
DMX
Activates when your device enters DMX mode
MASTER
Activates when your device enters MASTER
mode
SLAVE
Activates when your device enters SLAVE mode
SOUND
Flashes when your devices enters music-sen-
sitive mode
2
Display
Allows you to configure your projector. Please refer to next
chapter for more details about menu functions. The backlight
can be disabled via the Backlight Auto command from the
menu.
3
Display and menu buttons
Display
Allows you to intuitively configure your device. Please refer to
next paragraph for more details about the menu functions. The
backlight can be turned off via the Backlight function from the
menu.
MODE
Button
ALlows you to access the menu and select a function.
ENTER Button
Allows you to enter sub-menus and apply changes.
UP and DOWN buttons
Allows you to increase or decrease parameter values.
4
DMX input/output
3-pin XLR plugs hardwired as follows:
- Pin 1: Mass
- Pin 2: Negative signal
- Pin 3: Positive signal
5
Inserts for fixation system
Connect your quicklock fastening system to hooks, then use
these inserts to connect the projector to the quicklock fasteners.
6
5-pin
DMX input/output
5-pin XLR plugs hardwired as follows:
- Pin 1: Mass
- Pin 2: Negative signal
- Pin 3: Positive signal
Pins 4 and 5 are not connected.
7
Power input/output
Input: allows you to connect your projector to the mains via 2
poles + terre / Powercon
©
IN cord
Please make sure the voltage of your workplace matches this
projector.
Output: allows you to connect your projector to another
projector via Powercon
©
IN/OUT cord.
You can daisy-chain up to 10 projectors with identical
requirements.
8
Fuse
If need to change the fuse, please make sure the new fuse has
the exact same characteristics as the old one.
9
Vents
Please make sure the vents are not blocked at any time.
10
LED panel
11
Transport handles
When handling your projector, please always use the handles to
carry it, as any other part might break due to the weight.