Le Club HEZO300ZR User Manual - page 7
English
HEZO300ZR
-Moving head with 19 x 15W 4-in-1 RGBW LEDs, pixel and zoom
Page 7
Menu
Sub-menu
Action
Fixture Setting
(last part)
White Balance
The «white balance» function allows you to calibrate the colours of your
projector. It allows you to manually set Red, Green, Blue and White levels which
will then apply to each colour.
Select a colour, then use the UP and DOWN buttons to adjust values from 125
to 255.
125 means the colour intensity is reduced by half.
Cooling Mode
Allows you to adjust the cooling system behaviour:
-
Auto
: Fans are controlled internally
-
Low
: Fans are always at their lowest
Dimmer Curve
Linear
Brightness settings are proportional to values
indicated by the display.
Square Law
Brightness settings are exponential
Inverse Squ.
Brightness settings are inversely exponential
S-Curve
Brightness settings increase slowly in lower
values and sharply in high values
Dimmer Speed
Allows you to adjust the dimmer speed:
SMOOTH
: Smooth dimmer
SPEED
: Instant dimmer
Display Setting
Display Inverse
Allows you to rotate the display by 180°
Backlight Auto Off
Allows you to turn off the backlight when the screen has been inactive for 3
seconds
Backlight Intensity
Allows you to increase or decrease contrast.
From 1 to 10.
Temperature Unit
Allows you to modify the temperature unit.
Celsius or Fahreinheit degrees.
Display Warning
Activate this option for the display to flash when no DMX signal is detected.
Langage
Allows you to configure the language:
English
or
Chinese
Fixture Test
Auto Test
Automatically tests each function of your projector
Manual Test
Manually tests each function of your projector
Fixture
information
Fixture Use time
Display the total use time of your projector
Firmware Version
Displays the current software version
Reset Functions
Resets the following functions:
- Pan/Tilt
- Zoom
- All
Special Functions
Fixture Maintenance
Interval
Displays the time between two maintenance
operations
Remain Time
Displays the remaining time before maintenance
operations are required
Factory Setting
Displays the remaining time before maintenance operations are required
Factory Setting
Resets back to factory settings.