Leatt-Brace ADVenture User Manual - page 4
Step 1
Your ADVenture™ brace is supplied with three pairs of different sized Pins for adjustment. The
Medium Pin is fi tted as standard. To begin with, fi t your brace without the thoracic assembly on your
shoulders and chest as shown below in Figure 2.
Adjustment with Pins
If the brace is too loose around your neck
with the fi tted Medium Pin and does not
sit comfortably on your shoulders and
chest, fi t the Short Pin (see Figure 3).
If the brace is too short and therefore too
tight, simply fi t the Long Pin.
Fitting the Pins
Unscrew the 2 Buttonhead Cap Screws (see Figure 4a) with the supplied Allen key. Slide the Pin
out once the Cap Screws are removed (see Figure 4b) and replace by sliding the desired Pin back
in the same way. Now screw in the 2 Buttonhead Cap Screws with its washers in place to secure
the newly fi tted Pin.
Change Pin size
to short or long
according to fi t
Ensure comfortable
fi t to chest
Brace fi tted without the
thoracic assembly on
the back assembly
Ensure comfortable
fi t to shoulders
Short Pin (0mm)
Medium Pin (10mm)
Long Pin (20mm)
Figure 3:
Pin sizes
™
05
06
Instruction Manual Leatt-Brace
®
ADVenture™
Welcome to the world of Leatt-Brace
®
and thank you for choosing our product. The Leatt-Brace
®
you have purchased is based on years of academic research, extensive evaluation of the
mechanisms of head and neck injuries, together with testing, both in test facilities and with
simulation software, and also in conjunction with top drivers and riders.
Our design philosophy has always been to produce an effective neck injury prevention device
with practical appeal as determined by our test riders. We will therefore always appreciate your
feedback with regards to comfort and practicality for your chosen application of our product.
Please e-mail any comments you might have to info@leatt-brace.com.
For fi tment, please follow this easy fi tment guide. The size of brace you have purchased should be
correct for your body shape and allows for adjustability to ensure correct fi tment and comfort no
matter what your application is.
The Leatt
®
ADVenture™ Brace (Figure 1) has been designed to be set up in stages to suit your
requirements. Please follow the fi tment process which should take you about 20 minutes to complete.
Back Assembly
Front Assembly
Thoracic Assembly
Please note: The product
shown may vary in colour. Brace
components are illustrated in
contrasting colours to indicate
individual identifi cation.
Figure 1
Buttonhead
Cap Screws
Fitted
Medium Pin
Slide Pin in or out
in this direction
Figure 4a:
Back Assembly
Figure 4b:
Figure 2
Copyright © 2008, Leatt® Corporation
Copyright © 2008, Leatt® Corporation