Leatt-Brace ADVenture User Manual - page 7
™
CHEST STRAP
Once your Adventure™ Brace is set up
correctly to your body size and shape, attach
the chest strap (see Figure 11a).
The chest strap can provide additional stability
and comfort.
The back portion of the Chest Strap has
controlled stretch and should be attached with
the Velcro
®
on the thoracic assembly (Figure 11b).
The front portion of the Chest Strap has no
stretch and should be attached with the
Velcro
®
on the underside of the lower
portion of the front assembly
(Figure 11c).
Fasten the plastic clips on each side of the strap by
clipping one into the other (Figure 11a & 11c).
You can tighten or loosen the excess tension strap
for comfort and stability.
Figure 11a
11
12
Fitting the
ADVenture™ Brace
with a Riding Jacket
The ADVenture™ Brace can be worn
very comfortably and unobtrusively with
a Riding Jacket. When wearing a Riding
Jacket with the brace, ensure that the
brace rests comfortably over your jacket
(see Figure 10a & 10b).
The Riding Jacket will be diffi cult to close
properly if an attempt is made to wear
the ADVenture™ Brace underneath the
jacket.
Refer to Step 1 to adjust the fi t and
comfort of your brace on the chest and
back.
Figure 10a & 10b:
Your ADVenture™
Brace may be worn comfortably over
your Riding Jacket.
Figure 10a
Figure 10b
Figure 11b
Figure 11c
Figure 11d
Fastening clip with
adjustable tension strap
Copyright © 2008, Leatt® Corporation
Copyright © 2008, Leatt® Corporation