Lectrosonics SMDWB Instruction manual - page 21
Digital Hybrid Wireless Belt-Pack Transmitters
Rio Rancho, NM
21
Transmitter
Operating frequencies:
Band A1: 470.100 - 537.575
Band B1: 537.600 - 614.375 (608.000 to 614.000 excluded)
Band B2: 563.200 - 639.975 (608.000 to 614.000 excluded)
Band C1: 614.400 - 691.175
NOTE: It’s the user’s responsibility to select the approved
frequencies for region where the transmitter is operating
Channel Spacing:
Selectable; 25 or 100 kHz
RF Power output:
Switchable; 25, 50 or 100 mW
Compatibility Modes:
Digital Hybrid Wireless
®
(NU Hbr),
200 Series, 100 Series, Mode 3, Mode 6, IFB
Pilot tone (Digital Hybrid Mode):
25 to 32 kHz; 5 kHz deviation
Frequency stability:
± 0.002%
Deviation:
± 75 kHz max. (Digital Hybrid Mode)
Spurious radiation:
Compliant with ETSI EN 300 422-1
Equivalent input noise:
–125 dBV, A-weighted
Input level:
If set for dynamic mic:
0.5 mV to 50 mV before limiting
Greater than 1 V with limiting
If set for electret lavaliere mic:
1.7 uA to 170 uA before limiting
Greater than 5000 uA (5 mA) with limiting
Line level input:
17 mV to 1.7 V before limiting
Greater than 50 V with limiting
Input impedance:
Dynamic mic:
300 Ohms
Electret lavaliere:
Input is virtual ground with servo adjusted
constant current bias
Line level:
2.7 k ohms
Input limiter:
Soft limiter, 30 dB range
Bias voltages:
Fixed 5 V at up to 5 mA
Selectable 2 V or 4 V servo bias for any electret
lavaliere
Gain control range:
44 dB; panel mounted membrane switches
Modulation indicators:
Dual bicolor LEDs indicate modulation
–20, -10, 0, +10 dB referenced to full modulation
Controls:
Control panel w/ LCD and 4 membrane switches
Low frequency roll-off:
Adjustable from 35 to 150 Hz
Audio Frequency Response:
35 Hz to 20 kHz, +/-1 dB
Signal to Noise Ratio (dB):
(overall system, 400 Series mode)
(Note: the dual envelope “soft”
limiter provides exceptionally
good handling of transients
using variable attack and release
time constants. The gradual onset of limiting in the design begins below full modulation,
which reduces the measured figure for SNR without limiting by 4.5 dB)
SmartNR
No Limiting
w/Limiting
OFF 103.5 108.0
NORMAL 107.0
111.5
FULL 108.5 113.0
Specifications
Total Harmonic Distortion:
0.2% typical (400 Series mode)
Audio Input Jack:
Switchcraft 5-pin locking (TA5F)
Antenna:
Flexible, unbreakable steel cable.
Battery:
AA lithium, disposable
Battery Life w/ Lithium AA:
SMWB 50 mW (1 AA):
7.25 hrs
SMWB 100 mW (1 AA):
5.5 hrs
SMDWB 50 mW (2 AA):
14.5 hrs
SMDWB 100 mW (2 AA):
14 hrs
Weight (w/ litium batteries):
SMWB: 2.7 oz.. (75.9 grams)
SMDWB: 3.7 oz.. (105 grams)
Overall Dimensions:
SMWB: 2.3 x 1.8 x 0.64 inches;
(without microphone)
58 x 46 x 16 mm
SMDWB: 2.3 x 2.4 x 0.64 inches;
58 x 60 x 16 mm
Emission Designator:
180KF3E
Recorder
Storage media:
microSDHC memory card
File format:
.wav files (BWF)
A/D converter:
24-bit
Sampling rate:
44.1 kHz
Recording modes/Bit rate:
• HD mono mode:
24 bit - 144 kbytes/s
32 bit - 192 kbytes/s
• Split gain mode:
24 bit - 288 kbytes/s
32 bit - 384 kbytes/s
Input
Type:
Analog mic/line level compatible;
servo bias preamp for 2V and 4V lavaliere
microphones
Input level:
• Dynamic mic: 0.5 mV to 50 mV
• Electret mic: Nominal 2 mV to 300 mV
• Line level: 17 mV to 1.7 V
Input connector:
TA5M 5-pin male
Audio Performance
Frequency response:
20 Hz to 20 kHz; +0.5/-1.5 dB
Dynamic range:
110 dB (A), before limiting
Distortion:
Operating temperature range
Celsius:
-20 to 50
Fahrenheit:
-5 to 122
*microSDHC Logo is a trademark of SD-3C, LLC
Specifications subject to change without notice.