Ledj ALU ZOOM PAR 64 User Manual - page 6
Alu Zoom Par 64
Operations
1, Static colour mode
Mode button - By pressing the “MODE” button under the LED display, the LED display will show
“CL0”, then you can select one of the 7 static colours using the “UP” and “DOWN” buttons. The
Colours range from 1 - 7 and are listed below:
1, Red
2, Green
3, Blue
4, Purple 5, Yellow
6, Cyan
7, White
2, 3 Colour change mode
Mode button - Press the MODE button until the LED display shows “J00”, then the unit will run in
3 Colour change mode. Select the speed from 01 - 99 via the
“UP” and “Down” buttons.
(01 = Slow, 99 = Fast)
3, 7 Colour change mode
Mode button - Press the MODE button until the LED display shows “J.00”, then the unit will run
in 7 Colour change mode. Select the speed from 01 - 99 via the
“UP” and “Down” buttons.
(01 = Slow, 99 = Fast)
4, 3 Colour fade mode
Mode button - Press the MODE button until the LED display shows “F00”, the unit will then run in
3 Colour Fade mode. Select the fade speed from 01 - 99 via the
“UP” and “Down” buttons.
(01 = Slow, 99 = Fast)
5, 7 Colour fade mode
Mode button - Press the MODE button until the LED display shows “F.00”, the unit will then run
in 7 Colour Fade mode. Select the fade speed from 01 - 99 via the
“UP” and “Down” buttons.
(01 = Slow, 99 = Fast)
6, Auto Run mode
Mode button - Press the MODE button until the LED display shows “A--”, the unit will then run
in Auto Run mode. The Par Can alternates automatically between colour fade and colour change
modes using the speed that you have previously set by following the instructions above.
7). Sound active
Mode button - Press the MODE button until the LED display shows “S00”, the unit will then run in
Sound Active mode. Select the sensitivity level from 01 - 30 via the
“UP” and “Down” buttons.
Please note: The higher the value the more sensitive it will be.
9). Slave mode
Link the units together using a 3-pin DMX cable, then press the
MODE button to select one of the
above modes. On the Slave units press the mode button until the LED display shows
“SLA”. The
Slave units will then follow in sequence with the Master unit.