Ledj Quad illuminator User Manual - page 5
Quad illuminator
Operation Modes
Operation modes
Built-in programmes:
To activate the units built-in programmes, press the
“MODE” button to show “1.STATIC” on the
LCD screen. Press the
“ENTER” button to choose between the 4 built-in programmes by
using the
“UP” and “DOWN” buttons. Now press the “ENTER” button to select the desired speed
and adjust by using the
“UP” and “DOWN” buttons. Press the “ENTER” button once more to
select the desired flash value and adjust by using the
“UP” and “DOWN” buttons.
Speed values: 00 - 99 (00 = slow, 99 = fast)
Flash values: 00 - 99 (00 = slow, 99 = fast)
Programme 1 - Static colour
In this mode you can set the Quad illuminator to any colour and any brightness.
When you are in the
“1.STATIC” mode, press the “ENTER” button to change the brightness of
each individual colour.
The
“R” represents Red, “G” = Green, “B” = Blue, “W” = White and “F” = strobe.
The two digits after it are the brightness 00 to 99 or in “CF” they are the strobe speed.
Example:
If you set R, G, B and W all to zero, the Quad illuminator will have no LEDs showing (blackout).
If you set R to 99 and G, B and W to zero the Quad illuminator will be 100% Red.
Programme 2 - 15 colour change
In this mode the Quad illuminator will run through its 15 preset colours.
Programme 3 - 4 colour change
In this mode the Quad illuminator will run through its 4 colours.
Programme 4 - colour fade
In this mode the Quad illuminator will fade through its 15 preset colours.
DMX mode:
To activate the unit in DMX mode, press the
“MODE” button to show “DMX MODE” on the LCD
screen. Press the
“ENTER” button and select the desired DMX address setting by using the “UP”
and
“DOWN” buttons. Then to select one of the 3 DMX modes 3, 4 or 7 channel,
press the
“ENTER” button again to choose the desired DMX mode by using the “UP” and
“DOWN” buttons.
For the 3, 4 or 7 channel DMX address information please see page 5
NOTE: Once the desired settings have been selected in each of the above modes,
ALWAYS
confirm the settings by pressing the
“ENTER” button.
Slave mode:
To activate the unit in slave mode, first you must link multiple units together and press the
“MODE” button to show “SLAVE MODE” on the LCD screen. Now on the master unit press the
“MODE” button to select the desired mode and the slave units will now run in sequence with the
master unit.
4.