Leema-acoustics TUCANA II Handbook - Connecting Lips
Connecting LIPS
using the supplied LIPS lead.
LIPS leads are directional. The direction is governed by the plug colour. Remember - ‘Black out, Red in’.
Tucana II as LIPS slave: If you own a Leema CD player, it will normally be the master. In this case, connect the black plug to either
LIPS socket on the player and the red plug to either socket on Tucana. Set The player to LIPS master, choosing ‘Tucana II’ in its menu.
All functions will now be controlled from the player.
Tucana II as master or part of a chain: If you own other Leema units which will form a chain, such as Hydra and Corvus, connect
the black plug to Tucana and the red plug to the next unit: Tucana=Black->Red=Hydra, Hydra=Black->Red= Corvus etc.
Audio Specifications
Power Output: 8 ohms: 150 Watts RMS per channel, 4 ohms: 290 Watts RMS per channel
Minimum load impedance: 2 ohms.
Output Current: greater than +/- 50 Amps
Frequency response +0/-3dB @ 1W: 5Hz - 100kHz
Noise (A weighted, volume control minimum): -100dBm
Signal to Noise ratio (A weighted, ref: 285 Watts RMS 4 ohms): -104dB
THD (10 Watts RMS 4 ohms, 1KHz): 0.004%
THD (Max output before clipping, 4 ohms, 1KHz): 0.004%
Maximum DC offset: +/- 15mV
Sensitivity for maximum output (CD input): 565mV RMS
Sensitivity for maximum output (other inputs): 311mV RMS
Output Impedance: 0.05 ohms Damping Factor (8 ohms): 160
Specifications subject to change without notice.
Audio Specifications
TUCANA II
16