Legacy ML-3215 Operating Manual - page 10
If you choose the IDCS tone code setting, you will need to use the up or down buttons to select the desired tone code of 105
available. If you choose IDCS code 023, your display will read:
If you choose IDCS code 754, your display will read:
When the desired IDCS tone code appears on the display, select and set your choice by pressing the MODE button or the P-
T-T. The radio will save your selection and return to standby mode.
IDCS Tone Signaling Frequency Table
IDCS
Code
IDCS
Code
IDCS
Code
IDCS
Code
IDCS
Code
IDCS
Code
IDCS
Code
IDCS
Code
IDCS
Code
IDCS
Code
IDCS
Code
754
654
526
454
371
315
252
205
134
072
031
743
632
523
452
365
311
251
174
132
071
026
734
631
516
446
364
306
246
172
131
065
025
732
627
506
445
356
274
245
165
125
054
023
731
624
503
432
351
271
244
162
122
053
723
612
466
431
346
266
243
156
116
051
712
606
465
423
343
265
226
155
115
047
703
565
464
413
332
263
225
152
114
043
664
546
462
412
331
261
223
145
074
036
662
532
455
411
325
255
212
143
073
032
To set the per-channel radio transmit output power, press and release the MODE button, then the up or down buttons until
appears. Press the MODE button to select. Scroll through the sub-menu settings with the up or down buttons, press the
MODE button when
appears. Settings include:
You can toggle between these per-channel settings with the up or down buttons. When the desired setting appears on screen,
press the MODE button to select. The radio will save your selection, and return to standby mode. The display
will show an “H” or an “L” to confirm High (45 Watt) or Low (2 Watt) output power setting for the current channel.
To set the normal scan list on/off setting, press and release the MODE button then the up or down buttons until the
display appears. Press and release the MODE button again to select. Scroll through the sub-menu settings with the up
or down buttons, press the MODE button when
appears on screen.
appears. Settings include:
You can toggle between these settings with the up or down buttons. When the desired setting appears on screen, press
the MODE button to select. The radio will save your On or Off selection for the current channel, and return to standby mode.
NOTE: Your radio will only scan channels with the scan setting “On”.
To set the Priority scan list on/off setting, press and release the MODE button then the up or down buttons until the