Legacy ML-3215 Operating Manual - page 11
display appears. Press and release the MODE button again to select. Scroll through the sub-menu settings with the up
or down buttons, press the MODE button when
appears on screen. Settings include:
and
.
You can toggle between these settings with the up or down buttons. When the desired setting appears on screen, press the
MODE button to select. The radio will save your On or Off selection for the current channel, and return to standby mode.
NOTE: This setting is linked to the Priority Scan sub-menu in the “System Option” menu, detailed following this section. “If
Priority Scan option of “System Option” menu is on, Priority scan works only when the channel selector is positioned to the
channel with “PSCAN ON” displayed.”
To set the two-tone option, press the MODE button then the up or down buttons until the
display appears. Press and
release the MODE button again to select. Scroll through the sub-menu settings with the up or down buttons, press the MODE
button when
appears on screen. Settings include:
You can toggle between these settings with the up or down buttons. When the desired setting appears on screen, press the
MODE button to select. Next, toggle between On and Off status settings which occur for each above sub-menu.
Example:
,
and
.
When the desired setting appears on screen, press the MODE button to select. The radio will save your On or Off selection for
the current channel and return to standby mode. NOTE: Individual, Group and Super Group frequencies and timing are
programmed by your radio communications Dealer.
For quick reference, the next few pages detail the Channel Options Menu, sub-menus and their settings.
Mode Option Setting
Each Channel Setting
System Option Setting
Display Option Setting
Channel Option Setting
To
n
e
Option
Rx Tone
Tx Tone
No Tone
CTCSS
DCS
Invert DCS
1 ~ 49
023 ~ 754
023 ~ 754
No Tone
CTCSS
DCS
Invert DCS
1 ~ 49
023
~ 754
023 ~ 754
P/A mode Setting