Leggero TRAK User Manual - page 19
TRAK
User Manual
Page 19
4.14 Seat Extension Installation
If your Trak chair was originally configured with
a seat depth of 8 inches or less, you will need to
install the seat depth extension and longer seat
tubes supplied with the chair to increase the seat
depth beyond 9 inches.
1. Remove seat cushion.
2. Remove seat depth adjustment knob and
carriage bolt.
3. Remove front seat plate assembly.
4. Install seat extension 1 using 4 socket
head bolts 2 . 5mm hex wrench required.
Reference Figure 24.
5. Remove short seat tubes 3 from front seat
assembly. 4mm hex wrench and 10mm
wrench required. Reference Figure 25.
6. Install long seat tubes 4 with same hardware.
Reference Figure 26.
7. Install front seat plate assembly and adjust to
desired seat depth.
8. Install carriage bolt and tighten knob.
9. Install seat cushion and tighten straps.
1
2
Figure 24
Figure 26
Figure 25
3
4