1. DL manuals
  2. Leggett & Platt
  3. Indoor Furnishing
  4. U-232
  5. Owner's Manual

Leggett & Platt U-232 Owner's Manual

Manual is about: Custom Choice Collection ULTRA FURNITURE DESIGN

Summary of U-232

  • Page 1

    U-232 ultra ™ furniture design owners manual.

  • Page 3

    Contents advisory ...................................................................................................................... 4 acoustics .................................................................................................................... 6 fabric cleaning information .......

  • Page 4: Warning

    Ultra ™ furniture design owners manual 99301592 4 important information read the following information carefully before using this product electrical rating input - 100-240v, 50/60hz, 1.5a; output - 29vdc, 5.0a. Electrical grounding this product is equipped with a polarized or grounded electrical po...

  • Page 5

    Ultra ™ furniture design owners manual 99301592 5 advisory read the following information carefully before using this product important information pacemaker warning this product produces a vibrating sensation. It is possible that individuals with heart-assist pacemakers may experience a sensation s...

  • Page 6

    Ultra ™ furniture design owners manual 99301592 6 acoustics lifting/lowering mechanisms the lift/lower feature will emit a minimal humming sound during operation. This is normal. During operation, the lift arm wheels make contact with the platform support of the base. This applies slight tension on ...

  • Page 7

    Ultra ™ furniture design owners manual 99301592 7 installation for installation and setup, complete the following procedures, in the order indicated below and on the following pages: step 1 before discarding any packing materials, check the adjustable base shipping carton and verify the following it...

  • Page 8: Warning

    Ultra ™ furniture design owners manual 99301592 8 installation installation step 2 remove the hardware box. Cut zip-tie and remove mattress retainer. Step 3 install (4) legs into the base frame. Simply screw each leg into a tapped hole at the corner of the base frame ( figure 2). Step 4 carefully li...

  • Page 9

    Ultra ™ furniture design owners manual 99301592 9 installation step 7 install batteries in remote control (3-aaa, included) ( figure 3). Note: make sure batteries are properly oriented. Briefl y activate all functions of the base with the remote control to verify all features are in working order. I...

  • Page 10

    Ultra ™ furniture design owners manual 99301592 10 installation note: if base is to be set up without a headboard, basic installation is now complete. If headboard is to be installed, proceed to headboard bracket installation. Step 9 install corner mattress retainers at the foot end of the adjustabl...

  • Page 11: Warning

    Ultra ™ furniture design owners manual 99301592 11 3 inches max. Figure 7 headboard bracket installation installation failure to follow headboard bracket installation instructions may cause headboard bracket interference with base foam during base operation. Base foam or base cover damage could resu...

  • Page 12

    Ultra ™ furniture design owners manual 99301592 12 step 10 install headboard brackets to the adjustable base frame as follows: a. Using the remote control, raise the head section of the base as far as it will articulate to gain access to the adjustable base frame. B. Insert a 1/2” carriage bolt into...

  • Page 13

    Ultra ™ furniture design owners manual 99301592 13 c. Locate (2) holes in base frame at one corner of head end of base. Place the headboard bracket weldment underneath base frame and against the head end of the base, positioning the bracket weldment so the carriage bolt appears through the innermost...

  • Page 14

    Ultra ™ furniture design owners manual 99301592 14 installation d. Place headboard fl ange weldment against headboard bracket weldment. Install (2) 1” long hex bolts through slots in headboard bracket weldment and holes in headboard fl ange weldment ( figures10 and 11). Secure using (2) hex nuts. Lo...

  • Page 15

    Ultra ™ furniture design owners manual 99301592 15 installation f. Measure the center-to-center distance between the mounting slots of the headboard bracket fl anges. G. If bracket fl ange adjustment is required to accept the headboard, remove the 1 inch long hex head bolts and move fl anges side-to...

  • Page 16

    Ultra ™ furniture design owners manual 99301592 16 power down operation to lower the base to the fl at position during an electrical power outage, complete the following procedure: step 1 verify power is unplugged from electrical power source. Step 2 locate (1) power brick ( figure 13) and (2) 9 volt...

  • Page 17

    Ultra ™ furniture design owners manual 99301592 17 step 4 press the head down button on the remote control until the head section is fl at, then press the foot down button on the remote control until the foot section is fl at ( figure 15). Step 5 remove two (2) 9 volt batteries from power brick. Plu...

  • Page 18

    Ultra ™ furniture design owners manual 99301592 18 remote control function remote control requires three (3) aaa size batteries (included). Note snore button press and hold to raise head to the preprogrammed position. Head will automatically lower to fl at after 15 minutes. *to program a position, a...

  • Page 19

    Ultra ™ furniture design owners manual 99301592 19 remote control programming (1 remote control - 1 base) program one remote to operate one base - perform the following numbered procedure. Step 1 unplug the adjustable base electrical power cord from power source. Wait 30 seconds, then plug back in. ...

  • Page 20

    Ultra ™ furniture design owners manual 99301592 20 remote control programming (1 or 2 remote controls - 2 bases) base 1 base 2 figure 19 dual sync cable figure 21 control box control box male plug female plug female plug dual sync cable cable removed from control box figure 22 or remote 1 remote 2 p...

  • Page 21

    Ultra ™ furniture design owners manual 99301592 21 remote control programming (separating 2 bases) separate two bases - for independent adjustable base movement, perform the following numbered procedure. Step 1 unplug both bases from electrical power outlet. Position both bases on their sides, in cl...

  • Page 22

    Ultra ™ furniture design owners manual 99301592 22 usb outlets usb outlets these bases are equipped with (2) working usb outlets located on either side of the base that allow you to charge low voltage electronic devices such as cell phones, tablets, and/or laptops directly from the base ( figure 27)...

  • Page 23

    Ultra ™ furniture design owners manual 99301592 23 troubleshooting if the adjustable base fails to operate, investigate the symptoms and possible solutions provided in the chart below: symptom solution • verify power cord is plugged into a working, grounded electrical outlet. A grounded, electrical ...

  • Page 24

    Ultra ™ furniture design owners manual 99301592 24 accessories optional equipment contact customer service toll free (800-888-3078) to order the accessories indicated in the chart below. Tbd tbd 4b7410 4b1209 head board brackets-txl head board brackets-fxl/q bed link kit (connects two bases together...

  • Page 25

    Ultra ™ furniture design owners manual 99301592 25 1 year, 3 year and 25 year limited warranty in this warranty: “ adjustable base” means the adjustable bed foundation sold by l&p to the dealer. The “adjustable base” does not include the mattress. “ l&p” means leggett & platt, incorporated. “purchas...

  • Page 26

    Ultra ™ furniture design owners manual 99301592 26 1 year, 3 year and 25 year limited warranty repair or replacement shall be the sole remedy of the purchaser. There shall be no liability on the part of l&p for any special, indirect, incidental, or consequential damages or for any other damage, clai...

  • Page 28

    99301592 edr13436 2/16 nationwide customer service toll free: (800) 888-3078 © 2016 leggett & platt adjustable bed group, a division of leggett & platt incorporated.