Leggett & Platt U-232 Owner's Manual - page 20
ULTRA
™
furniture
design
owners manual 99301592
20
REMOTE CONTROL PROGRAMMING (1 or 2 remote controls - 2 bases)
BASE 1
BASE 2
FIGURE 19
DUAL SYNC
CABLE
FIGURE 21
CONTROL
BOX
CONTROL
BOX
MALE
PLUG
FEMALE
PLUG
FEMALE
PLUG
DUAL
SYNC
CABLE
CABLE
REMOVED
FROM
CONTROL
BOX
FIGURE 22
OR
REMOTE 1
REMOTE 2
Program One Remote to Operate Two Bases (Tandem Syncing)
- perform the following numbered procedure.
Note: Make sure
both remotes are in “press & hold” mode and both bases are fl at
before beginning procedure.
STEP 1
Plug both adjustable bases into electrical power source.
Operate both remote controls to verify each remote
functions properly with its respective base.
NOTE: see
1-to-1 programming procedure if bases do not operate.
Using remote controls, adjust both bases to fl at position.
Unplug both bases from electrical power outlet.
STEP 2
Choose base 1 remote. Retain base 2 remote control as a
spare or use if 2 remotes are desired to operate both bases.
STEP 3
Position both bases on their sides, in close proximity
to each other.
CAUTION: AT LEAST TWO PEOPLE
ARE RECOMMENDED FOR HANDLING AND MOVING
ADJUSTABLE BASE.
STEP 4
Locate dual sync cable (
FIGURE 19).
FIGURE 20
CONTROL
BOX
STEP 5
On base 1, unplug the existing cable from the control box
(
FIGURE 20). Insert one male plug of dual sync cable into
the control box (
FIGURE 21). Insert removed cable into
the female plug of the dual sync cable (
FIGURE 22).
STEP 6
Repeat Step 6 with base 2, using the remaining male and
female plugs of the dual sync cable.
STEP 7
Turn both bases over so they are resting on their legs.
CAUTION: MAKE SURE CABLE IS CLEAR OF BASE AND FREE
OF ANY PINCH POINTS.
STEP 8
Plug both bases into electrical power source.
STEP 9
Operate both bases with the remote control.
NOTE: If bases
do not operate in unison with the remote, verify dual sync
cable connections are fully seated in both MFP ports. Unplug
both bases, wait 10 seconds, then plug them back in.
EXISTING
CABLE