Leggett & Platt U-232 Owner's Manual - page 18
ULTRA
™
furniture
design
owners manual 99301592
18
REMOTE CONTROL FUNCTION
REMOTE CONTROL REQUIRES THREE (3) AAA SIZE BATTERIES (INCLUDED).
NOTE
SNORE BUTTON
Press and hold
to raise head to the
preprogrammed position. Head will
automatically lower to fl at after 15
minutes.
*To program a position, adjust base to
desired position, press and hold the set
button until the massage motors turn on
and off, then press and hold the Snore
button until the massage motors turn on
and off.
SET BUTTON
Press and hold to program Cust 1, Cust 2
and Snore presets.
M1 BUTTON
Press and hold
to adjust base to the
programmed position.
*To program a position, adjust base to
desired position, press and hold the set
button until the massage motors turn
on and off, then press and hold the M1
button until the massage motors turn on
and off.
M2 BUTTON
Press and hold
to adjust base to the
programmed position.
*To program a position, adjust base to
desired position, press and hold the set
button until the massage motors turn
on and off, then press and hold the M2
button until the massage motors turn on
and off.
HEAD MASSAGE UP/DOWN BUTTON
Press to increase or decrease massage
intensity. Massage has 3 speeds:
Low, medium and high. Massage will
automatically shut off after 15 minutes.
FOOT MASSAGE UP/DOWN BUTTON
Press to increase or decrease massage
intensity. Massage has 3 speeds:
Low, medium and high. Massage will
automatically shut off after 15 minutes.
MASSAGE ON/OFF BUTTON
Press “on” to turn both massage motors
on. Press “off” to turn both massage
motors off.
FOOT UP/DOWN BUTTON
Press and hold
to raise or lower the foot
section.
FLAT BUTTON
Press and hold
to lower the base to the
level position.
HEAD UP/DOWN BUTTON
Press and hold to raise or lower the head
section.
PILLOW TILT UP/DOWN BUTTON
Press and hold to raise or lower the
pillow tilt section.
UNDERBED LIGHT BUTTON
Press to turn underbed light on. Press
again to turn underbed light off.
LOCK BUTTON
Press to lock remote control. Press again
to unlock remote control.
PRESS & HOLD TO ONE TOUCH
To change remote control functions from “press and hold” to “one touch” (“one touch” = press and release), simultaneously
press the
HEAD MASSAGE DOWNandFOOT MASSAGE DOWNbuttons for 5 seconds. The massage motor will turn on and off
confi rming the change. Your base is now set to “one touch.”
When in “one touch” mode:
Custom 1, Custom 2, and Snore buttons
Press and release (one touch) button. Base will adjust to the programmed position. Press any other button to stop the base during movement.
Flat button
Press and release (one touch) button. Base will shut off massage motor, if active, and adjust base to level position. Press any other
button to stop the base during movement.
To revert back to
factory settings, simultaneously press and hold the SET button and the FLATbutton for 5 seconds. The massage
motor will turn on and off confi rming the change. Your base is now set to factory settings.
Note: Custom 1, Custom 2, and Snore
positions will revert to factory preprogrammed positions.