Lockwood Digital Deadbolt User Manual - Install Lock
7
Figure 3A
(2) M4 x 25.4mm
[8-32 x 1"]
Flat Head
Combination Screws
(2) M4 x 25.4mm
[8-32 x 1”]
Flat Head
Combination Screws
1
2
Figure 4A
“Tongue”
Inside of Door
Figure 4B
Figure 3B
3. Install outside escutcheon.
As you position the outside escutcheon, route the
cable through 54mm diameter hole (Figure 3A).
5. Secure both assemblies using (2)
M6 x 54mm pan head machine
screws (Fig. 4B), making sure that
outside escutcheon is vertically
aligned. Hand-tighten until snug.
Do not over-tighten
1. Install bolt in door.
NOTE: The bolt must be in a retracted (unlocked) position
when installing the lockset.
Attach with (2) M4 x 25.4mm screws supplied.
2. Install strike on the door frame, making sure to allow for the
bolt to be centred in the strike.
4. Holding the outside escutcheon flush to the door,
positioning the inside mounting plate by first routing the
cable and connector through the mounting plate’s 1/2” hole,
then inserting the mounting plate “tongue” into the bottom
slot of the outside escutcheon. See (Fig. 4A).
NOTE: Cable goes under bolt (see Fig. 3B).