Logan 750-1 Instruction And Operation Manual - Simplex Elite Mat Cutter

Simplex Elite Mat Cutter

Instruction Manual 

Model 750-1 760-1

13

Logan Graphic Products Inc.,  1100 Brown Street, Wauconda, IL 60084  847-526-5515  

LoganGraphic.com

1.  Remove mat guide and slip sheet.

2.  Slide rail stops to top of rail or remove 

(Fig. 42).

3.  Set squaring arm stop to dimension of cut.

4.  Place clean glass under guide rail 

(Fig. 43) and against squaring arm.

5.  Squeeze a drop of cutting oil onto glass wheel 

(Fig. 44).

6.  Hook glass cutter onto guide rail past end of glass. Pull cutter until wheel hits glass 

(Fig. 45).

7.  Pull glass cutter, keeping even constant downward pressure. Press hard enough to score 

glass but not to flake or chip surface. 

NOTE: Only score glass once. Do not retrace score. 

8.  Slide glass to align score with edge 

(Fig. 46) of board.

9.  Press down on overhanging glass to separate 

(Fig. 47).

Change Glass Cutting Wheel

1.  Loosen wheel shaft knob 

(Fig. 48).

2.  Carefully remove wheel and shaft.

3.  Slide wheel off shaft 

(Fig. 49).

4.  Replace new wheel on shaft.

5. Reassemble.

Fig. 42

Fig. 45

Fig. 48

Fig. 46

Fig. 49

Fig. 44

Fig. 43

Fig. 47

704-1 Glass Cutter

Glass Cutting Instructions

Oil

Shaft

Wheel  

Shaft Knob

Glass Cutting Wheel