Logan 750-1 Instruction And Operation Manual - Simplex Elite Mat Cutter
Simplex Elite Mat Cutter
Instruction Manual
Model 750-1 760-1
5
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 847-526-5515
LoganGraphic.com
Fig. 12
Fig. 11
Fig. 10
Fig. 9
Fig. 8
Squaring Arm Assembly
1. Line up squaring arm along side of slot, ensuring the bottom of the v-groove is
underneath screw
(Fig. 8).
2. Slide into the channel
(Fig. 8).
3. Align slots and tighten screw
(Fig. 9).
4. Slide stop onto squaring arm
(Fig. 10).
Straight Cutting Board to Size
1. Remove mat guide and slip sheet.
2. Set squaring arm stop to dimension of cut. Place mat (color side down) under guide
rail and against squaring bar stop
(Fig. 11).
3. Set the proper depth setting on the straight cutting head.
4. Hook the straight cutting head onto the guide rail past the end of the board to be cut.
Grasp the handle as shown in the picture, pivot down and pull the straight cutting head
towards you. Keep constant downward pressure on the straight cutting head and the guide
rail as you make your cut
(Fig. 12).
CAUTION: Be careful to control the straight cutting head as it breaks through the
end of the matboard, as it will tend to “jump” towards you.
Bevel Cutting Mat Openings
Cutting Bevel Mats Using Line to Line Method
EXAMPLE: Cutting a mat with a 2” border.
1. Move stops out of cutting area or remove from rail
(Fig. 13).
2. Set the mat guide to the desired border width. For example, for a
2” border, align the front of the mat guide at the 2” mark and tighten
the black knobs
(Fig. 14).
3. Make sure the slip sheet is in place before bevel cutting. You
must use a slip sheet. The straight cut slot underneath the
guide rail is for straight cutting only.
Fig. 14
Fig. 13
Mat Guide