Logan 750-1 Instruction And Operation Manual - Simplex Elite Mat Cutter
Simplex Elite Mat Cutter
Instruction Manual
Model 750-1 760-1
6
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 847-526-5515
LoganGraphic.com
Fig. 16
Fig. 18
Fig. 17
4. Place the mat color side down under the guide rail and up against the squaring bar and mat guide
(Fig. 15).
5. Using a pencil, draw a line down the full length of the back of the matboard. Turn the mat after each marking and repeat
this for the remaining three sides
(Fig. 16).
6. Attach the 702-1 bevel cutter to the guide rail by fitting the black nylon guides over the raised edge of the channel.
7. Position the cutter so the start & stop line lines up with the marked line closest to the top of the machine
(Fig. 17).
8. With left hand, depress the anti-crawl pin and firmly pivot the blade holder down into the mat
(Fig. 17).
9. Release the anti-crawl pin and pull the cutting head towards you until start & stop line lines up with
bottom pencil line
(Fig. 18).
NOTE: It is essential to keep even downward pressure on the blade holder as you cut.
10. Rotate the blade holder back up to the neutral position, turn the mat 1/4 to the right. Complete this for the remaining three sides.
Bevel Cutting Mat Openings Using One Rail Stop
EXAMPLE: Cutting a mat with a 2” border.
1. Set the mat guide to the desired border width. For example, for a 2” border, align the front of the mat guide at the 2” mark
and tighten the black knobs
(Fig. 14).
2. Install or slide bottom rail stop over guiderail scale and set at 2”
(Fig. 19).
3. Place the mat to be cut into the machine colored side down with the slip sheet underneath and lower the guide rail
(Fig. 15).
4. Using a pencil, mark one line along the full length of the matboard using the guide rail as a guide
(Fig. 16). Turn the mat
1/4 turn to the right before cutting.
5. Attach the 702-1 bevel cutter to the guide rail by fitting the black nylon guides over the raised edge of the channel.
6. Position the cutter so the start & stop line lines up with the marked line closest to the top of the machine
(Fig. 17).
Fig. 15