Logenex A202CR Installation & programming - page 21
Page 19
My phones ring as soon as the wires are plugged
into the door station.
Communication is very low when talking to the
door station.
My phones ring pattern is the same as an
incoming call and I cannot tell the difference
between the two.
Door stations #3 and #4 do not ring when I push
the door station button.
I cannot make outgoing long distance phone
calls.
My TeleDoorBell is not cal forwarding to the
assigned number.
There is no video feed coming out of door station.
Video feed does not modulate or picture quality is
poor on assigned channel.
Problem
Solution
1)The line you are connected on may have high
speed DSL internet on it. This will create
interference. A properly installed LX-DSL3F high
speed filter is required.
1)The unit is set on 6 standard ring pattern.
Please refer the ring pattern setting.
2)Your phones/phone systems do not recognize
’s distinctive ring pattern.
(PAGE 13)
TeleDoorBell
1) The
may not be an A204 model.
Please refer to model label on controller and or
barcode on unit box.
TeleDoorBell
1)Call restriction may be enabled. Please refer
the programming section to clear memory bins.
2)A factory reset may be required. Please refer to
programming section.
(PAGE 13)
(PAGE16)
1)Try reprogramming the call forwarding number.
2) Try Adding a pause or pauses ( ) before the
call forwarding number.
3)Call forwarding may not be enabled. Please
refer to the call forwarding section in the
User Guide.
*
1)Check for proper DC voltage power to the door
station.
2)You may be broadcasting on a channel with
signal already present. An appropriate filter
may be required.
TroubleShooting
Problem
Solution
Please check these items before calling for support.
Problem
Solution
1)The red and green wire to the door station is
either reversed, has a short, or has a break in
connection. (verify this by plugging the door
station in another available speaker relay port).