Logic TRM120 Operator's Manual - page 12
12
7.1 – BEFORE USE INSPECTION:
Ensure that all nuts, bolts and fittings are secure before using the TRM120.
Ensure the tyres are in good condition and have the correct pressures.
Ensure the swivel hitch is in good condition; replace any worn or damaged parts.
7.2 – ATTACHMENT TO TOWING VEHICLE
Any suitable vehicle can tow the Logic TRM120 normally by its 50mm swivel hitch coupling.
Ensure the hitch is securely attached to the towing vehicle and the handle indicator points to
“OK” before moving the vehicle.
Use the raise and lower levers to lift the TRM120 clear of the ground. Drive around for a short
period of time in a wide open space to ensure you become familiar with the operating width and
handling of the machine.
7.3 – ADJUSTING THE MOWER
MOWER ENGINE MUST BE SWITCHED OFF WHEN ADJUSTING THE MOWER!
DRAWBAR PITCH ADJUSTMENT
The hitch attachment height of the towing vehicle can vary. To accommodate this adjustment, a
screw link is located on the drawbar. This should be lengthened or shortened so that the cutting
deck is horizontal to level ground. (This ensures a better cutting efficiency)
1. Unlock the locking nut (A)
2. Lengthen the link to lower the front of the deck or shorten to raise the deck, by turning
handle (B).
3. Once the deck is level, re-tighten locking nut (A).
SETTINGS & ADJUSTMENTS
7
A
B