Logic TRM120 Operator's Manual - page 14
14
STARTING THE ENGINE
READ AND UNDERSTAND THE ENGINE OPERATORS MANUAL BEFORE USE
OBSERVE ALL SAFETY PRECAUTIONS; KEEP HANDS AND FEET AWAY FROM
THE ROTOR AND OTHER MOVING PARTS.
KEEP SPECTATORS AT A SAFE DISTANCE
1. Make sure there is a gap between the blades and the ground / crop
2. Select an area clear of loose debris.
3. Set the engine choke (if necessary) and suitable idling speed with the throttle.
4. Place one foot on top of the deck body to give a firm and balanced position. Pull the starter
cord firmly, allowing the cord to return to the housing slowly (one or two strong pulls should
start the engine).
5. After a few seconds warming up at idling speed, move the throttle to the factory pre-set max
engine RPM.
ELECTRIC START
Push button electric start engine options can be supplied if required. Simply hitch up the
mower, connect the electrical supply plug to the ATV socket and press the ignition button to
start the mower. Observing all the precautions mentioned above in ‘Starting the mower’.
REMOTE THROTTLE CONTROL
When a remote throttle control option is fitted, normally to the rear carrier frame of an ATV or
other suitable position on the towing vehicle, it gives the operator the facility of controlling the
mower engine from the operating position.
If the throttle is altered to increase the engine R.P.M beyond the recommended level, the
guarantee will become invalid. In addition to this, cutting efficiency will be reduced, fuel
consumption will increase and excessive vibration could be caused, resulting in a potential
danger to personnel and damage to components.