M-LOCKS T8530 User Instructions - page 3
USER INSTRUCTIONS
T8530
M-LOCKS BV
Tel: +31 (0)314 376 876
Vlijtstraat 40
ver. 1.0 2010 12 29
Fax: +31 (0)314 376 878
NL-7005 BN Doetinchem
3
www.m-locks.com
•
If button is pressed, the system will automatically select the following day of the week,
and the entered data will not be saved.
•
At the end of the list the LCD display will show the following message:
To enter further periods, press button . The system will select the current day. Enter new periods
as above. Repeat the procedure until the end of the list.
Press button to exit the Menu.
The entry unit will check the validity of the entered data. In case an error is found, the display will show
an error message.
NOTE: Time Lock periods cannot overlap; if so, only the last entered period will be accepted.
Standard week: “Verify & Delete”
When this function is selected, the LCD display will show all entered Time Lock periods in order of
time, starting from the current day.
•
To run the Menu, press button until LCD display shows the message ´End of List´.
•
To delete a period, press button . The LCD display will show the following message:
•
Press button to confirm and remove the period.
Special Events: “Add”
When this function is selected, the display will show the following message:
Enter the special event period.
•
Press the button to confirm and save.
•
If the button is pressed, the system will exit this function without saving the entered data.
The entry unit will check the validity of the entered data. If any error is found, the LCD display will
show en error message.
NOTE:
•
The programmed period will be repeated every year.
•
15 different periods are available. A period can not exceed 14 days.
•
Special event periods cannot overlap. If so, only the last entered period will be accepted.
Exit from Master
Menu to save
00 : 00 TUE
00 : 00
Delete?
DD / MM hh : mm
DD / MM hh : mm