Mace Alert Solo MAS-WA-REM User Manual

Keychain Remote Control

Please keep these instructions in a safe place for future reference.

Kit contents:

1  Keychain Remote Control

1  12V alkaline battery (included)

1  User Guide

1. IntroductIon

The MaceAlert™ Solo Keychain Remote Control allows you to operate the MaceAlert™ Solo 

Wireless Alarm Panel remotely. Using the control, the system can be armed or disarmed and 

the siren can be activated instantly using the Panic function, if required.

2. operatIon

2.1  P

owering

uP

the

 K

eychain

 r

emote

 c

ontrol

The Remote Control includes a 12V alkaline battery. To activate, unscrew and remove the back 

of the Remote Control, and carefully remove the clear plastic insulation tab from the battery. 

If the battery is dislodged, replace it—noting the correct polarity shown inside the battery 

compartment. Replace the battery cover.

2.2  e

nrolling

the

 r

emote

 c

ontrol

onto

the

 P

anel

Before they can operate the system, new Remote Control devices need to be enrolled (added 

to the system) as follows:

Keys

Description

Note

1

(1234 or 4-digit 

PIN) + 

You must be in 

StandBY

mode before enrolling a new 

Remote Control onto the 

Wireless Alarm Panel

*To make sure you are in 

StandBY

 mode:

- Enter the default PIN “ 1–2–3–4 ” OR your new 4-digit PIN

- Press 

- The panel will display the below image while you are in 

StandBY

 mode:

(One beep indicates that you entered a valid PIN, three beeps 

indicate that an invalid operation was performed).

User Guide  

|

MaS-Wa-reM