Mace Alert Solo MAS-WA-REM User Manual - 2.5 Q
2
(1234 or
4-digit PIN) +
Enter the default PIN
“ 1–2–3–4 ” OR your new
4-digit PIN for setting
followed by
The panel will display the below image:
3
Press
then
to
enter the Remote Control
Deleting mode. Then input
the ID no. of the Remote
Control you wish to delete
from the system
• LCD display flashes the total number of remote currently
enrolled to the system (e.g. If the panel has 3 remotes enrolled
the LCD display will flash “03”)
• Input the remote ID no. (e.g. “02”) for the remote you wish to
delete (Inputting “00” will delete all remote controls)
• LCD display will then flash the total number of remotes
enrolled after deletion(One beep indicates that the remote was
successfully deleted from the panel)
4
Press
to complete
the setting
Confirm the setting and return the panel to
StandBY
by pressing
2.5 Q
uerying
the
iD n
umber
of
a
r
emote
c
ontrol
The ID number of a Remote Control device can be identified as follows:
Keys
Description
Note
1
(1234 or
4-digit PIN) +
You must be in
StandBY
mode before
querying the ID number
of a Remote Control
from the Wireless Alarm
Panel
*To make sure you are in
StandBY
mode:
- Enter the default PIN “ 1–2–3–4 ” OR your new 4-digit PIN
- Press
- The panel will display the below image while you are in
StandBY
mode:
(One beep indicates that you entered a valid PIN, three beeps indicate
that an invalid operation was performed).
2
(1234 or
4-digit PIN) +
Enter the default PIN
“ 1–2–3–4 ” OR your new
4-digit PIN for setting
followed by
The panel will display the below image:
3
Press
then
to go into Remote
Querying mode, and
then press any key on
the remote to check
its ID.
- After entering into Remote Querying mode, the LCD display
will flash the total number of remote controls currently enrolled to the
system (e.g. If 3 remotes are enrolled the LCD display will flash “03”)
- The ID No. of the Remote can then be checked by pressing
any key on the remote (e.g, if the LCD display flashes “02”
then that is the ID of the remote)
4
Press
to complete
the query
Complete the query and return the panel to
StandBY
by pressing
3. MaIntenance
The product may be cleaned with a soft damp cloth and then wiped dry. Do not use abrasive,
solvent based or aerosol cleaners as this may damage and/or discolour the product. Do not
allow water to enter or attempt to clean inside the unit.