Mace Alert Solo MAS-WA-REM User Manual - 2.3. O
2
(1234 or 4-digit
PIN) +
Enter the default PIN
“ 1–2–3–4 ” OR your new
4-digit PIN for setting
followed by
The panel will display the below image:
3
Press
then
to enter
the Remote Control Enroll
mode. Then press any key on
the new Remote Control to
enrol it onto the system.
LCD display flashes the ID no. of the remote to be enrolled
e.g. when enrolling the first remote ID no. “01” will flash. Once
the first remote is enrolled the “02” will flash ready for a second
remote to be enrolled (One beep indicates that the remote was
enrolled to the panel successfully)
Note: It is recommended that the ID No. is marked on the
remote in case it needs to be deleted at a later stage
4
Press
to complete the
setting
Confirm the setting and return the panel to
StandBY
by pressing
2.3. o
Perating
the
K
eychain
r
emote
c
ontrol
arM:
Pressing the
arM
button on the remote will arm the system, triggering the preset exit delay.
When triggered the Wireless Alarm Panel’s LCD display will flash Red and indicate the
triggered zone.
dISarM:
Pressing the DISARM button on the remote will disarm the system instantly and the system
will return to
StandBY
mode.
aLert:
Pressing the ALERT button on the remote will put the system into
aLert
mode and a chime
will sound if any of the sensors are triggered. The LCD display will flash Green and indicate
the triggered zone.
HoMe:
Pressing the HOME button on the remote will set the system in
HoMe
mode which will
operate the system in both
arM
and
aLert
modes in different preset zones.
panIc:
If the HOME and ALERT buttons are pressed together the systems alarm is immediately
activated.
2.4 D
eleting
a
r
emote
c
ontrol
from
the
P
anel
If a Remote Control device is damaged or lost, it can be deleted from the system as follows:
Keys
Description
Note
1
(1234 or
4-digit PIN) +
You must be in
StandBY
mode before deleting a
Remote Control from the
Wireless Alarm Panel
*To make sure you are in
StandBY
mode:
- Enter the default PIN “ 1–2–3–4 ” OR your new 4-digit PIN
- Press
- The panel will display the below image while you are in
StandBY
mode:
(One beep indicates that you entered a valid PIN, three beeps
indicate that an invalid operation was performed).