Macintosh C36 Owner's Manual - page 11
J. MUTE
Press the MUTE button to turn off the Main, Switched 1 and 2 outputs. A RED LED in-
dicator left of the pushbutton will illuminate to indicate the MUTE condition. Press MUTE
again to restore normal sound. The TAPE outputs are not affected by the MUTE button.
K. HEADPHONES
Plug in a pair of low impedance dynamic headphones to this jack for headphone listening.
L. PANLOC
Turn the PANLOC buttons approximately 1/4 turn clockwise to lock the C36 in place. Turn
the buttons counterclockwise to unlock the unit for removal.
Use good quality shielded cables to interconnect the associated equipment used with the
preamplifier. The installation of proper quality cables will insure the best possible performance
from your stereo system. Your dealer can advise you on the type and length of cables best
suited for your installation.
LISTEN FUNCTIONS
1. MAIN OUTPUTS
Connect a cable from the C36 Left channel LISTEN MAIN OUTPUT to the Left channel
power amplifier input. Connect a cable from the C36 Right LISTEN MAIN OUTPUT to the
Right channel power amplifier input.
2. SWITCHED 1 AND 2 OUTPUTS
Two additional power amplifiers or accessory components can be connected to the
SWITCHED 1 and 2 LISTEN OUTPUTS. Connect in a manner similar to the MAIN outputs.
Audio output signals are fed to these jacks only when the appropriate front panel SPEAKER
1 or 2 switches are pressed.
This switching capability is useful when additional power amplifiers are used to power
remote listening areas.
3. PROCESSOR-FROM and TO
An external signal processor can be added to the C36 which will affect only the LISTEN
MAIN and SWITCHED 1 and 2 outputs.
The PROCESSOR-FROM jacks have built-in switching contacts to allow normal signals to
pass through when no cables are connected. When an external processor is properly con-
nected, the program signals feed to the processor from the PROCESSOR-TO jacks, and return
to the C36 at the PROCESSOR-FROM jacks.
Connect a cable from the left channel processor output to the C36 left channel
PROCESSOR-FROM jack. Connect a cable from the right channel signal output to the C36
right channel PROCESSOR-FROM jack.
Connect a cable from the C36 left channel PROCESSOR-TO jack to the signal processor
left channel input. Connect a cable from the C36 right channel PROCESSOR-TO jack to the
right channel signal processor input.
WHEN AN EXTERNAL SIGNAL PROCESSOR IS CONNECTED TO THE C36, THE PRO-
CESSOR MUST BE TURNED ON AND OPERATING FOR A PROGRAM TO BE HEARD
THROUGH THE SYSTEM.
FRONT
PANEL
CONTROLS
HOW TO
MAKE
CONNECTIONS
ON THE
REAR PANEL
9