Macintosh C36 Owner's Manual - page 9
2. DRILL THE HOLES
Use a drill with a 3/16 inch (5mm) bit. Drill perpendicular to the front panel the six A and
B holes. Then, using a drill bit slightly larger than the tip of your saw blade, drill one hole
at each of two diagonally opposite corners. The holes should barely touch the inside edge
of the penciled outline. Before taking the next step, be sure the six A and B holes have been
drilled.
3. SAW THE PANEL CUTOUT
First make the two long horizontal cuts. Then make the two short vertical cuts. After the
cutout is finished, use a tile to square the corners and smooth any rough edges.
4. INSTALL THE PANLOC MOUNTING STRIPS
The hardware package includes two
mounting strips and two black flat head
6/32 x 1-1/4 inch (31.8mm) screws and
four 6/32 x 1-1/4 inch (31.8mm) fillister
head screws. Place a mounting strip
behind each edge of the cutout and
secure it to the back side of the panel in-
serting a black flat head 6/32 screw
through the center holes marked B on the
template. Make sure the screws are drawn flush or slightly into the wood before attaching
the PANLOC shelves.
5. ATTACH THE PANLOC SHELVES
Position the PANLOC shelves inside the
cutout with the short flange against the
front face of the cabinet panel. Fasten the
shelves by inserting two fillister head 6/32
screws through the holes in each of the
PANLOC shelf flanges, through the front
panel and into the threaded receptacle on
the mounting strips.
6. INSTALL THE C36
Guide the C36 AC power cord through the panel opening to the back of the cabinet. Slide
the unit into the opening, making sure the rails on the bottom of each side of the chassis
engage the tracks on the PANLOC shelves. Slide the unit completely into the cabinet until
the back side of its front panel is pressing gently against the front of the cabinet panel. Turn
the PANLOC buttons approximately one-quarter turn clockwise to lock the unit in the cabinet.
Turn the PANLOC buttons one-quarter turn counterclockwise to unlock the unit so it can be
removed from the cabinet.
7
INSTALLATION