Maclaren Twin triumph Assembly Instruction Manual - Warning:
3
EN
Instructions
IMPORTANT:
• READTHESEINSTRUCTIONSCAREFULLYBEFOREUSEANDKEEPTHEMFORFUTUREREFERENCE.
• APPLYBOTHBRAKESWHENPARKINGTHESTROLLER.
• YOURCHILDREN’SSAFETYMAYBEAFFECTEDIFYOUDONOTFOLLOWTHESEINSTRUCTIONS.
1 TOOPENTHESTROLLER
A Release BOTH storage clips.
B Open out the stroller.
C Using foot, push BOTH footplates down fully to engage the primary locks.
CAUTION:Ensurethatalllockingdevicesareengagedbeforeuse.
2 TOOPERATEBRAKES
A TO ENGAGE BRAKES: With foot, push BOTH brake levers to the far right.
B TO RELEASE BRAKES: Push BOTH brake levers to the far left.
NOTE:BOTHbrakesshouldbeapplied.
CAUTION:Parkingdeviceshallbeengagedduringtheloadingandunloadingof
children.
CAUTION:Ensureparkingdeviceisengagedbeforeleavingthebuggyunattended.
3 TOOPERATEFRONTWHEELSWIVELLOCKS
A TO LOCK SWIVELS: Align front wheels and press down on locking levers.
B TO UNLOCK SWIVELS: Raise locking levers.
4 SEATBELT/SHOULDERHARNESSOPERATION
WARNING:
AVOIDSERIOUS
INJURYFROMFALLINGORSLIDINGOUT.
ALWAYSUSESEATBELT.
TO FIT HARNESS:
A Pull shoulder straps over the childs shoulder then attach to the waist
clips by sliding strap loops onto the hooks.
B Insert both waist clips into the clasp, shoulder straps are secured once
the clips are fastened.
C Adjust strap lengths by sliding buckles. Belt and harness should be snug.
TO RELEASE HARNESS:
D Press the button on both the front and back of the clasp simultaneously
to release.
5 TOADJUSTSEATRECLINE
A TO RECLINE SEAT BACK: Locate adjustment strap on rear of seat back.
Squeeze fastener prongs and pull apart.
B TO RAISE SEAT BACK: From rear of stroller push seat back to upright
position and insert fastener securely into clasp.
C Further intermediate adjustment can be made by shortening or
lengthening the strap.
D After adjustment, secure the loose strap by attaching the Velcro pads.
6 ATTACHINGTHEHOOD
CAUTION:Overloadingmaycauseahazardousunstableconditiontoexist.
Maximumcarryingcapacityofhoodpouch-1.1lb(0.5kg.)perpouch.
A With stroller open, clip the hood to the handle tubes just
above the retaining rivets.
B Place the rear apron behind seat backs.
C Extend hoods and press down on both side hinges of each hood
to lock open.
D The hood is removed by firmly pressing down the hood release tabs.
7 TOFITTHERAINAPRON
A Place the apron over the hood.
B Attach two eyelets (one each side) to the hood clips.
C Attach two eyelets (one each side) to the front legs.
8 TOFITTHESHOPPINGBAGS
CAUTION:Overloadingmaycauseahazardousunstableconditiontoexist.
Maximumload4.4lb(2kg)evenlydistributed.
Thestrollermaybefoldedwiththebagsstillattachedbutallcontentsmustbe
removed.Failuretodothiscoulddamagestrollerandcontentsofshoppingbag.
A Place bags on the ‘X’ frame under seat with lowest edge of bag at front.
B Attach front straps to front legs just below seats.
C Attach rear straps to rear legs just above horizontal tie bars.
9 REMOVINGANDREFITTINGTHESEATLINERS
Theseatlinersmayberemovedforwashing.
Theseatlinersarereversible.
A Unclip all shoulder and waist straps.
B Twist crotch strap buckle and feed up through seat base and liner holes.
C Detach Velcro retaining straps from seat rear and slide seat liner from
seat base.
D feed waist straps and shoulder harness straps through holes in liner.
E Reverse this procedure to refit the seat liner ensuring crotch strap buckle
passes through seat liner hole and seat base hole.
10REMOVINGANDREFITTINGTHESEATCOVERS
Removerainapron,hoodandseatlinersfromstrolleriffitted.
A Twist shoulder strap end buckles and feed through holes.
B Feed waist and crotch straps through holes.
C Unclip seat cover retaining straps.
D Unfasten seat fabric from handle tubes and seat base.
E Slide fabric from seat back and base.
F Reverse this procedure to refit the seat cover and harnesses ensuring
seat back support tubes are inserted into fabric fold.
11TOFOLDTHESTROLLER
Removerainapronfromstrolleriffitted.
Ensuretheseatbackisinitsfullestuprightpositionandthehood
(iffitted)isfoldedback.
Removecontentsofshoppingbag.
Itisrecommendedthattheharnessisfastenedbeforefoldingthestroller.
A Ensure the seat backs are in the fullest upright position.
B Fold back the hood (if fitted).
C Using foot, lift up BOTH footplates to release primary locks.
D Push down on secondary lock lever.
E Grip handles and push forward.
F Compress folded stroller and engage BOTH storage clips.