MadMan AP-WRC2 Installation & User Manual - Ap-Wrc2
AP-WRC2
Installation & User Manual
Rev 0.2
4
Operation
4.1
INITIAL TESTING
1. Check that the fobs have batteries installed by pressing any button
and verifying that the red light on the fob turns on. If not, install new
CR2016 lithium batteries before proceeding further.
(Refer to section
5.2 for battery replacement instructions)
2. Confirm the autopilot has power to it by checking that the display is
on and displaying a value. Test the autopilot operates as per normal
from the autopilot’s own buttons by first pressing the ‘Auto’ key and
then pressing the course change buttons to alter position by 1 and
10 degrees to both port and starboard. Do not proceed until you
are satisfied the autopilot is operating normally.
3. Switch on the AP-WRC2 at it’s on/off switch (switch to ‘I’). Watch for
the LED indicator on the AP-WRC2 to flash 3 times indicating start
up.
(If the LED does not flash after turning the switch on, refer to the
troubleshooting section).
4. Press each button on each fob and verify that the LED indicator on
the AP-WRC2 turns on briefly with each button press.
(If the LED does
not turn on for any button presses, refer to the troubleshooting section).
5. Press the ‘Auto’ button on the autopilot to select Auto mode (for
ST1000/ST2000+ a letter ‘A’ appears next to the value on the
autopilot display).
6. Press Button A (or B) on one of the fobs and verify that the number
displayed on the autopilot changes by 1. (Note: the autopilot may
not move with only a 1 degree course change).
11