Magellan RTX3 Reference And Installation Manual - page 10
Page 10
Programming
RTX3 Programming Sections for EVO
Section
Feature
Details
[001]
RTX3 options
Option [1] Low battery
supervision
For RTX3 version 1.5 and higher,
this option is always On
(default: On).
Option [2] Check-in supervision default: Off
Option [3] Check-in supervision
time interval
Off = 24 hours (default)
On = 80 minutes
Option [4] RF Jamming
supervision
default: Off
Option [5] On-board module
tamper supervision
default: Off
Option [6] PGM1 initial state
Off = Normally Open (default)
On = Normally Closed
Option [7] PGM2 initial state
Off = Normally Open (default)
On = Normally Closed
Option [8] Transmitter tamper
signal
Off = RTX3 ignores tamper signal
(default)
On = RTX3 reports tamper signal
[002]
Remote control options
Option [1] REM2 Visual and
auditory feedback
compatibility
options*
Off = Old visual and auditory
feedback (Supported by
REM2 V2.00 or lower)
On = New visual and auditory
feedback (default)
(Requires REM2 V2.01 or
higher with K641 / K641R
keypads)
[030]
View transmitter, remote and
PGM serial numbers
To view a transmitter’s 6-digit serial
number, press and hold the
transmitter’s anti-tamper switch.
* The new visual and auditory feedback includes the following system
statuses: stay armed, instant armed and exit delay. Other status feedback has
not changed. Note that for REM2 versions 1.04 or older, stay arm, instant arm
and exit delay statuses are not supported, and a rejection beep will be heard
when the system is in these statuses.