Magellan RTX3 Reference And Installation Manual - Programming For Evo
Programming
Page 9
To program an RTX3 for an Imperial system:
1. When BabyWare is communicating with the V32 controller and an RTX3
module is connected to the Multibus, it automatically appears in the Modules
display area. To view the Modules display area, click the Modules toggle
button. Alternatively, you may wish to add a module to BabyWare before the
module is physically connected to the system. Click the Add Item button
and add the RTX3 from the Zone Expansion Modules list.
2. When the RTX3 is added to the system, double-click the module’s icon. The
RTX3 Programming window opens.
3. From the RTX3 Programming window, configure Input Setup and Input
options. Click OK.
Programming for Spectra SP Series
When connected to a Spectra SP series panel, the wireless settings are
programmed using control panel programming sections. Refer to the panel’s
Programming Guide.
NOTE: Programming for a Spectra SP series system requires K32 or K10V/H
keypads version 2.0 or higher.
NOTE: Only one RTX3 module can be connected to a Spectra SP Series
panel.
Programming for EVO
When connected to an EVO panel, the wireless settings are programmed in
Module Programming Mode.
To enter Module Programming Mode:
1. Press and hold the [0] key.
2. Enter your [
INSTALLER
CODE
].
3. Enter section [4003].
4. Enter the module’s [
SERIAL
NUMBER
]
5. Enter the required [
DATA
].
NOTE: When used without a K641 or K641R keypad, enable EVO option [1] in
section [3029].
After Programming for EVO
Program the zones, PGMs, and remotes into the EVO panel. Refer to EVO
section [3034] and RTX3 section [001]* options [2] and [3] for wireless
transmitter supervision options.
* For instructions on entering 3-digit RTX3 section numbers, see RTX3
Programming Sections for EVO on page 10.