Magenta Research MultiView II AK1200DP Installation And User Manual - Chapter 3
Specifications
MultiView™ II AK600DP/AK1200DP
Installation and User Guide
4
Chapter 3
Specifications
This section describes the following specifications:
General specifications
Category cable compatibility
3.1
General Specifications
The following table lists the general specifications of the MVII-AK600(1200)DP.
Table 2: MVII-AK600(1200)DP General Specifications
Item
Description
Cable Required
Category 5, 5e, or 6 cable. Shielded or unshielded twisted pair. Low-skew.
Compliance
CE; FCC Class A, IC Class A, UL listed I.T.E Device.
Video Support
All supported VESA modes to WUXGA (1920x1200), RGBHV, RGsB, RGBs, Composite
(NTSC, PAL, SECAM), S-Video, Component Video, widescreen modes, HDTV modes
including 1080p, 1080i, 720p
Resolution &
Refresh Rate
MVII-AK600DP:
At 600ft(183m) or less: a maximum of 1920x1200.
MVII-AK1200DP:
At 1200ft(366m) or less: a maximum of 1920x1200.
Required source
impedance
Video OUT: 75 ohms
Audio models: Audio OUT (if any): capable of driving 10K ohms load.
SPDIF audio mode: 75 Ohm
Required
destination
impedance
Video IN: 75 ohms
Audio models: Audio IN (if any): 1K ohms minimum input impedance
SPDIF audio mode: 75 Ohm
Audio
Characteristics
(S/A) model:
Right/Left summed, 50K input impedance, line level, unbalanced.
(SAP) models:
Full stereo, 10K ohms input impedance, line level, unbalanced.
Serial
Characteristics
(S/A) model:
Protocol: Asynchronous; transparent to data format; transparent to data
rates up to 115 kbps simplex.
(SAP) model:
Protocol: Asynchronous; transparent to data format; transparent to data
rates up to 19.2 kbps full duplex or simplex (9 fixed baud rates are supported).
Connectors
(1) 4 pin phoenix
(2) RJ-45 (1 input, 1 active loop-through)
(1) HD15 (F)
(1) DB9M (only if the SAP option module is installed)
(1) DC Power jack
Temperature
Tolerance
Operating: 32 to 104°F (0 to 40°C)
Storage: -4 to +140°F (-20 to +60°C)
Humidity Tolerance
Up to 80% non-condensing
Enclosure
Steel, black powder-coat finish.
Power
Input voltage: +5 VDC @ 1.2 Amps max.
Consumption: 6 watts maximum
Size
1.2"H x 3.6"W x 5.5"D (3.0 x 9.2 x 14.0 cm)
Weight
1.0 lb. (0.45 kg)