Magicbook SHB-V7S6 User Manual - page 102

On the Use of RF Device 

NOTE: The information in this section applies to models with the wireless LAN module. 

USA and Canada Safety Requirements and Notices 

IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the 

antenna used for this transmitter must be installed to provide a separation distance of at 

least 20 cm from all persons and must not be co-located or operating in conjunction with 

any other antenna or transmitter. 

Radio Frequency Interference Requirements and SAR

The FCC with its action in ET Docket 93-62 has adopted a safety standard 

for human exposure to Radio Frequency (RF) electromagnetic energy 

emitted by FCC certified equipment. The wireless LAN module meets the 

Human Exposure limits found in OET Bulletin 65, 2001, and ANSI/IEEE 

C95.1, 1992. Proper operation of this radio according to the instructions 

found in this manual will result in exposure substantially below the 

FCC’s recommended limits. The following safety precautions should be 

observed: 

Do not touch or move antenna while the unit is transmitting or 

receiving. 

Do not hold any component containing the radio such that the 

antenna is very close or touching any exposed parts of the body, 

especially the face or eyes, while transmitting. 

Do not operate the radio or attempt to transmit data unless the antenna 

is connected; if not, the radio may be damaged. 

Use in specific environments:

The use of wireless devices in hazardous locations is limited by the 

constraints posed by the safety directors of such environments. 

The use of wireless devices on airplanes is governed by the Federal 

Aviation Administration (FAA). 

B-6 Regulatory 

Information