Gas griddle installation & operation manual mkg24, mkg36, mkg48, mkg60 & mkg72 built after june 1, 2003 mailing - p.O. Box 501, concord, nh 03302-0501 shipping - 10 ferry st. Concord, nh 03301 tel: 800-258-3708 • 603-225-6684 • fax: 603-225-8497 www.Magikitchn.Com l25-050 rev. 0
Mkg series gas griddle installation & operation i this manual must be retained for future reference to the purchaser post in a prominent location the instructions to be followed in the event that an operator smells gas. Obtain this information from your local gas supplier. Warning there is an open f...
Mkg series gas griddle installation & operation ii table of contents 1. Installation section:................................................................................................................................................... 1 1.1. Checking your new griddle: ............................
Mkg series gas griddle installation & operation 1 1. Installation section: 1.1. Checking your new griddle: your new griddle has been carefully packed into one crate. Every effort has been made to ensure that your new griddle is delivered to you in perfect condition. As you unpack your new appliance,...
Mkg series gas griddle installation & operation 2 warning never supply the appliance with a gas that is not indicated on the data plate. Using the incorrect gas type will cause improper operation. If you need to convert the appliance to another type of fuel, contact your dealer. 1.3.1. Fuel types: e...
Mkg series gas griddle installation & operation 3 1.5. Installation, set up: the installation of this appliance must conform to local codes. In the absence of local codes, the installation must conform to the national fuel gas code, ansi z223.1; natural gas installation code, can/cga-b149.1; or prop...
Mkg series gas griddle installation & operation 4 1.5.3. For use on optional equipment stand: attention rear mounting brackets should be installed to the equipment stand prior to placing griddle on the stand. Caution only two of the four supplied casters are equipped with a locking feature. Install ...
Mkg series gas griddle installation & operation 5 1.6. Final gas connection: a properly installed gas supply system will deliver adequate pressure (7 to 8 inches w.C. For natural gas, 11 to 12 inches w.C. For propane) to all appliances connected to the line, operating at full demand. 1.6.1. Regulato...
Mkg series gas griddle installation & operation 6 1.6.2. Gas settings: orifices are sized to provide proper gas flow to the rated btu/hr for each model. Regulator pressure must be measured and adjusted before the unit goes into service, following installation and when operational performance is in q...
Mkg series gas griddle installation & operation 7 2.2. Initial startup: notice: new griddles should be carefully tempered and cared for in order to avoid possible damage. To break in a new griddle, do the following: wipe the griddle surface clean. A mild soapy water solution may be used to clean the...
Mkg series gas griddle installation & operation 8 22 0 14 0 22 0 14 0 25 0 20 0 150 °c °f 25 0 20 0 10 0 80 12 0 55 0 26 0 50 0 28 0 24 0 45 0 55 0 150 °c °f 10 0 80 12 0 50 0 26 0 28 0 24 0 45 0 160 30 0 350 180 400 200 350 180 30 0 160 400 200 3. Thermostat calibration section: each control typica...
Mkg series gas griddle installation & operation 9 4. Basic operation: 4.1. Operational helpful hints: a. Each thermostat controls 12" of griddle surface, whenever possible, use the leftmost or rightmost thermostats for the lowest cooking temperatures. The adjacent thermostats set at higher temperatu...
Mkg series gas griddle installation & operation 10 5. Cleaning & maintenance section: 5.1. Daily cleaning: a. Clean the griddle surface often to prevent sticking and poor quality of food product. Scrape the griddle plate regularly with a scraper intended for your type of griddle surfaces to remove a...
Mkg series gas griddle installation & operation 11 f. Check to see that the ventilation hood and make up air systems are working properly. Any make up air system should not be directed as to impede the flow of combustion air to the griddle, or flue exhaust from the griddle. G. Inspect griddle surfac...
Mkg series gas griddle installation & operation 12 using magikitch'n chrome griddle accessories are important to maintaining the life of the griddle's chrome surface. 5.5.2. Optional: to order accessories for your griddle, call your local magikitch’n dealer for prices and availability. *10" & 12" se...
Mailing address - p.O. Box 501, concord, nh 03302-0501 shipping address - 10 ferry st. Concord, nh 03301 phone- 800-258-3708 • 603-225-6684 • fax: 603-225-8497 www.Magikitchn.Com.
