1. DL manuals
  2. Magikitch'n
  3. Griddle
  4. MKG24
  5. Installation & Operation Manual

Magikitch'n MKG24 Installation & Operation Manual

Manual is about: all options

Summary of MKG24

  • Page 1

    L25-052 rev. 0 (5/06) installation & operation manual mkg24, mkg36, mkg48, mkg60 & mkg72 all options built after august 1, 2005 d e i f i t r e c d e s i g n c i r e t i f e d important for future reference please complete this information and retain this manual for the life of the equipment: model ...

  • Page 2

    To the purchaser, owner and store manager please review these warnings prior to posting them in a prominent location for reference. L25-052 rev. 0 (5/06) 2 to the purchaser post in a prominent location the instructions to be followed in the event that an operator smells gas. Obtain this information ...

  • Page 3

    Table of contents mkg series gas griddle l25-052 rev. 0 (5/06) 3 1. Installation section ...................................................................................... 4 1.1. C hecking y our n ew g riddle ..........................................................................................

  • Page 4

    Installation mkg series gas griddle l25-052 rev. 0 (5/06) 4 location combustible construction inches (centimeters) non-combustible construction inches (centimeters) cabinet back 8.0 (20.4) 8.0 (20.4) cabinet sides 2.0 (5.0) 0.0 (0.0) 1. Installation section 1.1. Checking your new griddle your new gr...

  • Page 5

    Installation mkg series gas griddle l25-052 rev. 0 (5/06) 5 warning never supply the appliance with a gas that is not indicated on the data plate. Using the incorrect gas type will cause improper operation. If you need to convert the appliance to another type of fuel, contact your dealer. 1.3.1. Fue...

  • Page 6

    Installation mkg series gas griddle l25-052 rev. 0 (5/06) 6 1.5.1. Counter use with legs caution to prevent equipment damage, do not tilt your magikitch'n griddle on only two legs, or on its sides. (see figure 2) a set of 4” legs is shipped with the appliance (unless appliance was specifically order...

  • Page 7

    Installation mkg series gas griddle l25-052 rev. 0 (5/06) 7 1/2" bolts (4) bracket (2) mount flush to front (supplied) (supplied) nuts & bolts included with stand rear figure 4 notice the larger units have 6 threaded receiving holes, but require only the four 1/2" bolts on each corner to mount the g...

  • Page 8

    Installation mkg series gas griddle l25-052 rev. 0 (5/06) 8 1.6. Final gas connection a properly installed gas supply system will deliver adequate pressure (7 to 8 inches w.C. For natural gas, 11 to 12 inches w.C. For propane) to all appliances connected to the line, operating at full demand. 1.6.1....

  • Page 9

    Operations mkg series gas griddle l25-052 rev. 0 (5/06) 9 left piezo ignitor right piezo ignitor left pilot button right pilot button pilot holes method a pilot ready light(s) pilot holes method b on/off(i/o) switch 2. Operation section ensure that a proper installation has been performed on the app...

  • Page 10

    Operations mkg series gas griddle l25-052 rev. 0 (5/06) 10 2.2. Initial startup notice new griddles should be carefully tempered and cared for in order to avoid possible damage. To break in a new griddle, do the following: wipe the griddle surface clean. A mild soapy water solution may be used to cl...

  • Page 11

    Calibration mkg series gas griddle l25-052 rev. 0 (5/06) 11 thermostat stem turn ccw to increase temperature turn cw to decrease temperature thermostat adjustment screw electric thermostats shown for reference removed, snap action thermostat knob 22 0 14 0 22 0 14 0 25 0 20 0 150 °c °f 25 0 20 0 10 ...

  • Page 12

    Basic operation mkg series gas griddle l25-052 rev. 0 (5/06) 12 4. Basic operation 4.1. Operational helpful hints 1. Each thermostat controls 12" of griddle surface, whenever possible, use the leftmost or rightmost thermostats for the lowest cooking temperatures. The adjacent thermostats set at high...

  • Page 13

    Cleaning & maintenance mkg series gas griddle l25-052 rev. 0 (5/06) 13 5. Cleaning & maintenance section 5.1. Daily cleaning 1. Clean the griddle surface often to prevent sticking and poor food product quality. Scrape the griddle plate regularly with a scraper intended for your type of griddle surfa...

  • Page 14

    Cleaning & maintenance mkg series gas griddle l25-052 rev. 0 (5/06) 14 9 check to see that the ventilation hood and make up air systems are working properly. Any make up air system should not be directed as to impede the flow of combustion air to the griddle, or flue exhaust from the griddle. 9 insp...

  • Page 15

    Trouble shooting mkg series gas griddle l25-052 rev. 0 (5/06) 15 5.6. Trouble shooting charts the following charts may help to eliminate any basic operational problems that you may be experiencing with your appliance. Locate the problem on the left side of the chart, and cross-reference with the pos...

  • Page 16: Surface

    Accessories mkg series gas griddle l25-052 rev. 0 (5/06) 16 6. Accessories 6.1. Standard all plain steel and chrome plated griddles are shipped with a set of 4” adjustable legs. The appliance also comes equipped from the factory with a manual gas shutoff valve, and the specified gas regulator for th...

  • Page 17

    Accessories mkg series gas griddle l25-052 rev. 0 (5/06) 17 towel bar only cutting boards are available on larger workshelves workshelves with and without towel bars pan cutouts and 6.2.2. Cutting boards other sizes are available, consult factory for size, price, and availability. Size part no. 8" x...

  • Page 18

    Accessories mkg series gas griddle l25-052 rev. 0 (5/06) 18 6.2.3. Warming shelves, rear shelf kits can be attached to existing models. The stainless steel shelf is removable from the shelf framework for easier cleaning if necessary. Shelf model part no. C/a, shelf rear mkg24 5225-1535701-c c/a, she...

  • Page 19

    Accessories mkg series gas griddle l25-052 rev. 0 (5/06) 19 6.2.4. Equipment stands equipment stands can be ordered with legs or casters (stands with casters shipped after may 2006 are equipped with adjustable casters). Note: it should also be noted that when ordering an equipment stand for your mkg...

  • Page 20

    Accessories mkg series gas griddle l25-052 rev. 0 (5/06) 20 accessory part no. 6" wall spacer, lh mkg 5425-1526701-c 6" wall spacer, rh mkg 5425-1526702-c utensil box, mkg 9825-1532501-c utensil box, mkg towel bar only 9825-1532502-c 6.2.5. Miscellaneous your appliance can also be used with the foll...

  • Page 21

    Notes mkg series gas griddle l25-052 rev. 0 (5/06) 21 7. Notes page.

  • Page 22

    Notes mkg series gas griddle l25-052 rev. 0 (5/06) 22 this page intentionally left blank.

  • Page 23

    Notes mkg series gas griddle l25-052 rev. 0 (5/06) 23 this page intentionally left blank.

  • Page 24

    L25-052 rev. 0 (5/06) in the event of problems with or questions about your order, please contact the magikitch’n factory at (800) 258-3708 us and canada only (603) 225-6684 world wide www.Magikitchn.Com in the event of problems with or questions about your equipment, please contact the magikitch’n ...