Magma ExpressBox 3T User Manual - page 11
Magma
ExpressBox 3T | Chapter 2 Hardware Installation
11
Install PCIe Cards
Some card manufacturers recommend that you install their software driver prior to installing the card. If this is the
case, be sure to install the card driver before connecting ExpressBox 3T to the computer.
•
Slot 1 accepts x1 or x4 PCIe cards or the provided Fan Blower
•
Slot 2 accepts x1, x4 or x8 PCIe cards
•
Slot 3 accepts all types of PCIe cards x1, x4, x8 or x16 (next to Thunderbolt interface card)
Make sure that all cards are fully seated in their connectors. When correctly seated, there will be a firm resistance
when you pull up gently on the card. To keep the cards in place, secure them in the enclosure with their retaining
screws.
After securing the cards verify that they do not touch each other.
NOTE
If at all possible, plug all power cords from the expansion chassis and your host computer into a
shared power strip, preferably one that has surge and noise suppression circuitry built into it.
WARNING
Do not remove or disconnect any cables from Thunderbolt interface card inserted in the ExpressBox
3T chassis. Doing so WILL disable functionality.