Magma ExpressBox 3T User Manual - page 24
Magma
ExpressBox 3T | Chapter 2 Hardware Installation
24
1. Connect the SAS / SATA Cable to controller card.
2. Plug in Controller Card and secure it.
How to Configure SAS / SATA Raid
IMPORTANT
This chapter describes how to configure the disk controller card. This software configuration is
specific only to vendor Areca. Different vendors (i.e. ATTO, Intel, LSI and etc.) of disk controller
cards have their own software utility for RAID configuration and management. If you are using a
non-Areca card make sure to check with the vendor or manufacturer of the card for further
instructions.
Areca has its own Graphical User Interface for RAID configuration and management.
You need to install Archttp first,
follow the instructions below
1. Go to
http://www.areca.com.tw
2. Click Support & Downloads
3. Go to Driver / Utility, select Windows
4. Under "Windows-ArcHTTP" click, Version V2.3.4 to download
5. Save File "winhttp_V2.3.4_130325.zip"
6. Extract the File
7. Click Install.exe to install Archttp
8. After Installation, shutdown computer. Connect Thunderbolt cable to Magma EB3T and computer.
9. Turn on the computer