Magma ExpressBox 3T User Manual - page 36
Manual is about: Thunderbolt to PCIe Expansion
of
52
Magma
ExpressBox 3T | Chapter 3 Verify Installation
36
LEDs D6 and D8 are illuminated when power cord is attached to expansion unit. This means the expansion unit is
on standby-mode. See picture below.
FIGURE T2-C
If the above LEDs are not coming ON, please check the power standby cable make sure it is firmly connected to
Thunderbolt Interface card power connector (J7). See page 25.
D6
D8
Thunderbolt™ 2 Interface Card LEDs: Standby-Mode