Magmaweld ID 350 E PFC User Manual - page 26
2.2 INSTALLATION AND WORKING RECOMMENDATIONS
24
ID 350 E PFC
2.1 UPON RECEIPT AND CLAIMS
Ÿ
Standard pallet contains:
ú
Power Source
ú
Earth Cable
ú
Electrod Holder
ú
User Manual
Ÿ
For a better performance, keep the machine at
least 30 cm away from the surrounding objects.
Beware of excessive heat, dust and humidity
around the machine. Try not to operate the
machine under direct sunlight. Machines should
be operated on lower capacities when ambient air
temperature exceeds 40ºC.
Ÿ
Avoid welding at outdoors where it is windy and
rainy, if this is a must, protect the welding area with
curtains, mobile screens or tents.
Ÿ
Use suitable welding fume extraction systems.
Use breathing apparatus if there is a risk of
inhaling in confined places.
Ÿ
Respect the duty cycles given at the data plate.
Exceeding the duty cycles frequently can damage
the machine and this would void the warranty.
Ÿ
Do not use stronger fuses than those stated on the
data plate.
Ÿ
Ensure that the earth clamp is tightly connected as
close as possible to the welding location. Do not let
welding current flow through any media other than
welding cables; e.g. over the machine itself, gas
tubes, chains, ball bearings, etc.
2.3 ELECTRIC PLUG CONNECTION
Figure 2: Electric Plug Connection
For your own safety, do not use the
mains cable of the machine without a
plug.
Ÿ
Be sure that you have received all the items that
you have ordered. In case of any item is missing or
damaged, contact your supplier immediately.
Ÿ
In the event of damaged or missing delivery, draw
up a record, take a photo of the damage and
report it to the shipping agency and MAGMA
MEKATRONIK with the photocopy of shipping bill.
E-mail: servis@magma.com.tr
Fax: +90 236 226 27 28
2. INSTALLATION
INSTALLATION
Ÿ
Since mains connection sockets may vary from
factory to factory, an appropriate plug must be
installed to the built-in mains cable of the machine
by qualified electricians. Please observe that the
earth cable is in yellow/green colour and labeled
as .
Ÿ
After installing the electric plug, DO NOT INSERT
IT INTO THE SOCKET AT THIS STAGE.