Magmaweld ID 350 E PFC User Manual - page 29
3.3 MMA WELDING
3.4 TOUCH-SCRATCH TIG WELDING
3.5 REMOTE CONTROL (OPTIONAL)
3.6 ERROR MESSAGES
Ÿ
It is possible to connect wireless or cable remote
control unit. In this case, appropriate control
socket must be installed onto the back cover by a
certified Magma Service.
Ÿ
When the remote control connector is connected
to the machine, ampere adjustment knob on the
machine is disabled automatically and current
adjustment is made by the remote control.
Ÿ
Push the welding mode selection button (10) for
selecting the stick electrode welding mode. Stick
electrode welding LED (13) ligths.
Ÿ
Adjust the current via current adjustment knob (7).
Ÿ
Below table can be used as a rough reference for
mild steel electrodes. For exact parameters,
please refer to the electrode manufacturer's
recommendations.
Ÿ
For better ignition turn the HOT START knob (11)
clock-wise. Welding arc can drill the metal when it
is very thin and hot start is high.
Ÿ
ARC FORCE is useful for electrodes which have
tendency to stick into the weld pool during welding.
Turning the knob (12) clock-wise will decrease the
tendency to stick. If ARC FORCE is adjusted too
high, spatter increases.
Ÿ
Start welding. You can observe welding current (A)
and voltage (V) by current display (8) and voltage
display (9).
Ÿ
Push the welding mode selection button (10) for
selecting Touch-Scratch TIG welding mode.
Touch-Scratch welding LED (14) lights.
Ÿ
Adjust the current via current adjustment knob (7).
Ÿ
Start welding. You can observe welding current (A)
and voltage (V) by current display (8) and voltage
display (9).
CODE
ERROR
POSSIBLE REASON
POSSIBLE REMEDY
ERR-T1
E2
E4
Thermal Error
Power Module Error
Overvoltage
Switch off and switch on. If the error still exists,
Check the mains voltage whether it is within the
range of 340V-420V or not. If the error still exists,
contact to your authorized technical service.
Check the mains voltage whether it is within the
range of 340V-420V or not. If the error still exists,
contact to your authorized technical service.
Machine is overheated because of high
ambient temperature or exceeding duty cycle.
Let the machine on for a while in order to cool
down itself with the cooling fan.
After it cools enough, you can go on welding.
Error/errors may exist in any electronic card.
Mains voltage is too high.
E8
Undervoltage
Mains voltage is too low.
Check the mains voltage whether it is within the
range of 340V-420V or not. If the error still exists,
contact to your authorized technical service.
27
ID 350 E PFC
OPERATION
Diameter
Rutile
Basic
Cellulosic
2.0
2.5
3.25
4.0
5.0
40-60 A
60-90 A
60-90 A
60-100 A
100-140 A
100-130 A
70-130 A
140-180 A
140-180 A
120-170 A
200-240 A
200-250 A
160-200 A
--
--
Type
6.0
260-300 A
--
--