Magmaweld ID 350 E PFC User Manual - Id 250E
3. OPERATION
3.1 CONNECTING TO THE MAINS
Figure 6: Mains Connection
OPERATION
Ÿ
Before plugging your machine to the electrical line
check with a voltmeter the correct voltages
indicated at the plate of the machine and then
insert the plug into the socket.
Ÿ
SWITCH ON the machine via ON/OFF switch (2).
Observe that the illumination of the displays and
LEDs are visible and the sound of the cooler fan is
hearable.
While inserting the plug into the
socket, pay attention that ON/OFF
switch is positioned to “0”.
3.2 CONTROL PANEL
[7] Current Adjustment Knob is used for adjusting
the welding current in a range of 5-300A.
[8] Current Display displays the welding current
during welding, displays the adjusted current when
the machine doesn't weld.
[9] Voltage Display displays the open circuit voltage
and the welding voltage during welding.
[10] Hot Start Adjustment Knob is used for a better
ignition in stick electrode welding.
[11] Arc Force Adjustment Knob is used for
reducing the electrode's tendecy to stick into the weld
pool during welding.
[12] Welding Mode Selection Button is used for
selecting either stick electrode welding mode or
touch-scratch TIG welding mode.
[13] Touch-Scratch TIG Welding LED lights when
touch-scratch TIG welding mode is selected.
[14] Cellulosic Electrode Welding LED lights when
cellulosic electrode welding mode is selected.
[15] Basic Electrode Welding LED lights when
basic electrode welding mode is selected.
[16] Rutile Electrode Welding LED lights when
rutile electrode welding mode is selected.
Figure 7: Control Panel
26
ID 350 E PFC
ID 250E
Arc Force
1
3
4
5
6
7
8
9
10
2
Rutile
Basic
Cellulosic
Hot Start
1
3
4
5
6
7
8
9
10
2
ID 350E
PFC
7
8
9
11
12
16
15
14
13
10